Gamma 7900 Els Owner's Manual - Control Panel Features
12
CONTROL PANEL FEATURES
Single Digit (1-9)
Memory LED Display
Three Digit (XX.X) Tension Setting
Display or String Length LED Display
12 Button Keypad - Used to enter tension settings
Tension Index Buttons - Changes
tension setting in +/- 1.0 or +/- 0.1 Lb or
Kg increments. Holding the button down
will scroll the tension setting values up
or down. Tension settings entered with
the tension index buttons are placed into
temporary memory setting “0”.
Clear Button - Clears display to enter
a new tension or to reset String Length
Meter measurement.
Test Button & Racquet Strung -
Press once for approximate number of
racquets strung. Press again to return.
Press and hold for 5 seconds and the
machine does an internal diagnostic
check, such as the one performed at
start-up.
Lbs/Kgs Button - Changes tension dis-
play from Lbs to Kgs. Each press of the
button toggles back and forth between
Lbs and Kgs.
Pre-Stretch Function - Pulls string 10%
or 20% over the tension setting (up to 90
lbs / 40.8 kgs), releases the string, and
repulls to the tension setting. Each press
of the button toggles between 10%, 20%
or no pre-stretch.
Memory Button - Indexes from 9 preset
tension settings that can be stored in
memory. Settings are retained even if
machine is turned off. Each press of
the button indexes to the next memory
setting. Memory settings 1-9 must be
entered using the keypad followed by
pressing the “ENT” button.
Enter Button - Saves displayed tension
for Memory setting - when tension is en-
tered using the keypad display fl ashes
until this button is pressed to save the
setting. Also Clears display for String
Length Meter measurements.
Knot Function - Increases pulling ten-
sion by 10% over the setting value (max
90 lbs / 40.8 kgs) for one pull. During the
pull the LED stays lit to indicate the Knot
function is enabled.
Speed Button - Changes pulling speed
of winder from Fast (default) to Medium
to Slow. Slow speed is recommended
for low stretch strings, such as Kevlar.
Each press of the button toggles be-
tween Fast, Medium and Slow speeds.
String Length Meter Button- Enables
string length meter function. Each press
of the button toggles between Meters
and Feet. To switch back to tensioning
function, press the “Lbs/Kgs” button.