Ganz ZN-D100VE Quick User Manual - page 3
2010/2‐1
3
Step2. Connect cables to IP device
Connect each cable to the device. To see the correct positions of all connectors, refer to the following image
below.
Step3. Set up network environment
The default IP address of your IP device is 192.168.XXX.XXX. You can find the available IP address from the
MAC address of your device. Please make sure the device and your PC are on the same network segment
before running the installation. If the network segment was different between your PC and the device, change
your PC’s settings as below.
IP address : 192.168.xxx.xxx
Subnet mask: 255.255.0.0
LAN
DC 12V
Make sure the polarity is correct. Incorrect connection may
cause malfunction or damage to the IP device.
Caution
!
Power Adaptor Connector (DC 12V)
* Models herein and their appearance
are subject to change without any prior
notice.