Summary of ZN-D2024
Page 2: Warnings Before Installation
Warnings before installation contact your distributor when such cases happen. Power off the ip camera as soon as it is found smoking or smelt unusual. Do not place the ip camera around the heat sources, such as television or oven. Keep the ip camera away from direct sunlight. Keep the ip camera away...
Page 3
Do not place the ip camera on unsteady surfaces. Do not disassemble the ip camera. Do not insert any object into the ip camera, such as needles. Do not touch the ip camera when it's lightening. Do not drop the ip camera. 2.
Page 4: Package Contents
Zn-d2024 power adapter warranty card quick installation guide software cd alignment sticker screws and i/o connector 3 package contents 1.
Page 5: Physical Description
Physical description 2 keep a note of the mac address before installing the camera. 001cb8600052 rohs pat. 6,930,709 indoor ip dome camera model no:zn-d2024-a drill holes dome cover 4 lens tilt screw built-in mic power cord socket ethernet 10/100 rj45 socket indented reset button audio out mic. In e...
Page 6: Hardware Installation
First, use the supplied screwdriver to detach the dome cover from the camera base. Then, follow the steps below to install the camera; either to a ceiling or to a wall. Hardware installation when mounting to a ceiling through the two holes on each side of the camera base, insert the supplied two scr...
Page 7: Network Deployment
6 general connection (without poe) 1. Connect the camera to a switch via a ethernet cable. 2. Connect the supplied power cable from the camera to a power outlet. Power collision link receive partition 1 2 3 4 5 1 2 ethernet switch network deployment 4.
Page 8
Power over ethernet (poe) power collision link receive partition 1 2 3 4 5 poe switch power collision link receive partition 1 2 3 4 5 non-poe switch poe power injector (optional) when using a poe-enabled switch the camera is poe-compliant, allowing transmission of power and data via single ethernet...
Page 9: Assigning Ip Address
8 this serial number is the same as ethernet address, for example: 001cb8600052=00-1c-b8-60-00-52 ganz installation tool 3. From the "ganz installation tool" window, click on the mac that matches the one you just noted from the product label of your device to connect the internet explorer to the ip ...
Page 10
9 for further setup, please check the user's manual on the software cd. The internet explorer connects to the ip camera 6.
Page 11: Adjusting The Lens
Based on the live image retrieved from the camera, adjust the camera lens by doing the following: to adjust the viewing angle 1. Loosen the pan screw and then turn the lens module left and right. Upon completion, tighten the pan screw. 2. Loosen the tilt screws on both side of the camera and then tu...
Page 12: Completion
625004100g attach the dome cover to camera body and make sure all parts of the camera are securely installed. 11 completion 8.