Ganz ZN-DNT352XE-MIR Quick User Manual

Page of 8

Download

Print this page

Bookmark us

NC3502 Ver1.3

ZN-DNT352XE-MIR

Quick User Guide

This manual provides instructions for quick installation and basic configuration of your IP device.

Step1. Connect cables to IP device

Connect required cables to the device including the power cable and LAN cable. To see the correct positions

of all connectors, refer to the following image below.

Make sure the polarity is correct. Incorrect connection may

cause malfunction or damage to the IP device.

Caution

Power Adaptor Connector (DC 12V)

* Model design and appearance are subject to change without any prior notice

Reset Button

Output Configuration

Switch

Clamping Core *This uses to prevent

electromagnetic

interference

LAN Cable

Power Cable

Clamping Core

*This button is

located under PCB.

1 2 3 4 5 6 7 Next › »

Summary of ZN-DNT352XE-MIR

Page 1
Nc3502 ver1.3 1 zn-dnt352xe-mir quick user guide this manual provides instructions for quick installation and basic configuration of your ip device. Step1. Connect cables to ip device connect required cables to the device including the power cable and lan cable. To see the correct positions of all c...
Page 2
Nc3502 ver1.3 2 step2. Install ip device caution ! To prevent products from damaging, place the camera on stable and non‐vibrating surfaces if the stability is in doubt, consult with safety personnel for reinforcements, and then proceed with the installation. 1) place the installation template (pape...
Page 3
Nc3502 ver1.3 3 step3. Set the lens position 1) remove the dome cover. 2) set the lens position by rotating the camera gimbal; to pan, rotate the reinforced lower body of the gimbal; to tilt, vertically adjust the camera gimbal. Caution ! Refrain from continuously rotating the camera gimbal with exc...
Page 4
Nc3502 ver1.3 4 step4. Set up network environment the default ip address of the device is 192.168.Xxx.Xxx. Users can identify the ip address of the device from converting the mac address’s hexadecimal numbers, which is attached to the device. Be sure that the device and pc are on a same area network...
Page 5
Nc3502 ver1.3 5 custom ip environment ipadmintool is provided with sdk at the following sdk path. {sdk root}\bin\tools\admintool\ ipadmintool is a management tool, which automatically scans all of the network products for users to perform administrative tasks, which includes network configurations, ...
Page 6
Nc3502 ver1.3 6 step5. View video on web page once the device has the proper ip address, users can view the live streaming images through a web browser. The default username and password is root / pass. 1. When the device’s web address is accessed, the browser asks to install the activex. Click allo...
Page 7
Nc3502 ver1.3 7 rebooting perform the following procedures to reset your device: 1. Press the reset button for 2 seconds. 2. The power led turns to red and wait for the system to reboot. Resetting to the factory default settings if you reset your device to the factory default setting, all parameters...
Page 8
Nc3502 ver1.3 8 hexadecimal-decimal conversion table refer to the following table when you convert the mac address of your device to ip address. Hex dec hex dec hex dec hex dec hex dec hex dec hex dec 0 0 25 37 4a 74 6f 111 94 148 b9 185 de 222 1 1 26 38 4b 75 70 112 95 149 ba 186 df 223 2 2 27 39 4...