Ganz ZN-DNT352XE-MIR Quick User Manual - page 3
of
8
NC3502 Ver1.3
3
Step3. Set the lens position
1) Remove the dome cover.
2) Set the lens position by rotating the camera gimbal; to pan, rotate the reinforced lower body of the
gimbal; to tilt, vertically adjust the camera gimbal.
Caution
!
Refrain from continuously rotating the camera gimbal with excessive force to a single direction
as it is attached with the IR‐LED cable inside the dome.
3) The figure and table below explains the lens switch settings.
SW1
SW2
SW3
PAL/NTSC
TELE
WIDE
SW4
SW5
SW6
FAR
NEAR
Auto‐
Focus
B. To pan, rotate the lower
body of the camera gimbal
C. Tilt the lens by vertically
adjusting the camera gimbal
A. To adjust lens position,
rotate the camera gimbal