Garaga CarGO 500 Owner's Manual - Warning
18
8-15. CONTROL PANEL
On the control panel (see Fig. 30) you will find circular LED display with 8
numbered icons which shows useful status information regarding the
perator and its function and 3 buttons labeled “+”, “-” and “P” which allows
you to set all the adjustments of your operator.
P
1
2
1
5
3
7
2
4
6
8
+
2
4
7
Fig. 30
Warning
In order to guarantee trouble-free programming, the
door must be in the CLOSED door position before
programming or system reset.
For proper initial operation of the operator, three basic functions must be
set using express programming:
• Open Door Position
• Close Door Position
• Transmitter Coding
Press and hold the “P” button for approximately 5 seconds. When LED’s 8,
1 and 2 illuminate, release the button. You are now ready to set or change
the desired adjustment. If no buttons are pressed within 120 seconds while
in programming mode, the control unit reverts back to operating mode.
TO MAKE OR CHANGE ANY ADJUSTMENT:
HANDY NOTE: If no changes are needed at any particular stage, you can
keep the current information and “skip” over a specific adjustment by
pressing the “P” button once. This is useful to know if you want to change
only one setting, without changing any of the other adjustments. Simply
enter the adjustment mode by pressing and holding the “P” button for
pproximately 5 seconds, then press and release “P” repeatedly until your
particular adjustment is reached. This bypasses the unneeded adjustments,
and takes you right to the adjustment you want. When your adjustment or
setting is complete, simply press ”P” as many times as needed to bypass
the remaining steps and exit out of the program, returning the operator to
normal mode.
Your new operator has automatic force learning and maximum force setting.
It may be required to change force settings. If the force needs to be
increased or decreased, it should be changed by one (1) increment at a
time. The force should be set as low as possible, just enough to allow your
unobstructed door to travel freely without reversing or stopping.
NOTE : You may exit the System Set Up at any time by pressing the button
“P” for more then 5 sec. The set up programming can be terminated at any
time and from any stage. To do so, press the “P” button for longer than 5
seconds. When programming is terminated, all LED’s light up once and then
turn off, one after the other.
1
2
Fig. 31
8-16. INITIAL SYSTEM SET UP
Key to icons and corresponding LED’S
Led 1 Photo eye sensors
Connectivity / Alignment indicator
Led 2 “OPEN door position”
Led 3 “No function during operation”
Led 4 “CLOSED door position”
Led 5 “Reference Point”
Led 6 “Malfunction”
Led 7 “Impulse (remote control)”
Led 8 “Power”