Garden Oasis 10 ft SQUARE COMMERCIAL OFFSET UMBRELLA Owner's Manual - page 5

Step 01:

Place Upper Bracket (B) onto Lower Bracket (A) as shown.

Step 02:

Loosen the screw (I) counterclockwise by using S5 Wrench (P), then take out 

Base Tube (C) from Sunshade (N).

Step 03:

(2) Line up the bolt holes on the 360° Revolve Device (F) with the corresponding 

bolt holes on the two brackets.  Then screw the M10x24 Bolts (D) on with Flat 

Washer (E) by using S8 Wrench (O).  Then screw Base Tube (C) on the 360° 

Revolve Device (F) by using the same method.

3

10x10′ Square Offset Umbrella Assembly Instruction

(1) Insert the Connecting Link (T) into 360° Revolve Device (F), then screw the 

M6x10 Bolts (H) by using S5 Wrench (P).