Gardena 1407 Operating Instructions Manual - 9. Faults
14
G
A
Attention ! Disconnect
the mains plug before
carrying out any work on the
system !
Cleaning the filter
(fig. F)
The pump is almost maintenance-
free.
It has an integrated filter which
needs to be cleaned in the follow-
ing way, after the system has
been shut-off :
1. Press both orange locking
knobs
A
and remove the
base of the pump (fig. F).
2. Take out the filter
0
and
rinse in clean water.
3. Replace the filter into the
suction base.
4. Re-connect the base to
the pump. Ensure that locking
knobs snap firmly into posi-
tion.
A
Attention ! The housing
of the pump is sealed at
the thread. Any work on elec-
trical parts must only be carried
out by GARDENA Service.
In frost affected areas the pump
and transformer must be stored
in a dry place.
Disposal :
(in accordance with
Directive 2012 / 19 / EU)
Device may not be added to nor-
mal household refuse but must
be disposed of in the technically
correct way.
8. Maintenance, care, storage
Fault
Possible cause
Remedy
Pump does not run.
Mains connector or pump
Insert the mains plug in the outlet
connector are not plugged in.
socket, or the pump connector
plug in the socket at the trans-
former.
Soil Moisture Sensor / Rain
Wait until the Soil Moisture
Sensor indicates moisture.
Sensor / Rain Sensor has dried
out sufficiently.
No water is delivered.
Container is empty.
Fill container with water.
The pump filter
0
is blocked.
Clean the pump filter
(section 8.1).
The watering cycles are
The adjustment knob
9
of
Set the adjustment knob exactly
incorrect.
the transformer is set in between
onto desired position.
programmes.
The system still runs after the
Inline Drip Heads are installed
Choose another location for the
pump has been turned off.
lower than water level in con-
container, where the water level
tainer.
is below the Inline Drip Heads.
Install an Inline Drip Head to vent
the system.
9. Faults
7.3 Sensor Operation
By selecting
programs 1 - 13
when the GARDENA Soil Mois-
ture Sensor (Art. No. 1188) is con-
nected, timer-controlled watering
is prevented or interrupted if the
soil is sufficiently moist.
Alternatively, by connecting the
GARDENA Rain Sensor (Art. No.
1189) watering can be prevented
or interrupted if it starts to rain.
By selecting
automatic program
14,
watering can be switched on
and off completely automatically
depending on the moisture level
of the soil. You must connect the
GARDENA Soil Moisture Sensor
(Art. No. 1188) (see also the notes
in the Soil Moisture Sensor oper-
ating instructions).