Gardena 380 EC Operating Instructions Manual - 3. Assembly
13
GB
Mowing correctly :
3. Assembly
1. Insert lower part of bottom upright
1
into upright holders
2
up to stop and
secure with the screws
3
.
2. Push connector
4
from underneath
into upper part of bottom upright
1
.
3. Insert threaded rod
6
from left
through lower parts of central
upright
5
, upper part of bottom
upright
1
and connector
4
right
up to the stop.
4. Slide threaded bearing
8
into
clamping lever
7
.
5. Screw clamping lever
7
onto
threaded rod
6
approx. 4 turns.
6. Move clamping lever
7
onto
connector
4
and check whether
clamping lever
7
locks.
7. If clamping lever
7
does not yet
lock, screw another turn onto
threaded rod
6
. Repeat procedure
until clamping lever
7
locks on
connector
4
.
8 Firmly attach bottom part of top
upright
9
to upper parts of central
upright
5
using 2 wing nuts
z
m
.
The safety starter lock
B
on the crossbar
9
must then
be on the left.
9. Fix the motor cable
0
to the upright with the two cable clips
A
.
4. Function
To produce a well-maintained lawn we recommend cutting the
lawn one a week if possible. The lawn becomes thicker if cut
frequently.
Relatively long cut grass (> 1 cm) must be removed so that the
lawn does not become yellow and matted.
After relatively long intervals between mowing
(holiday lawn)
, up
to max. 12 cm, first of all cut in one direction with the cutting height
as high as possible, then cut in the crosswise direction at the
cutting height required.
If possible, only cut the grass when it is dry, if the grass is damp,
the cutting pattern will be uneven.
The mains voltage and the equipment voltage
stated on the type plate must be the same. If
extension cables are used, these must comply
with the minimum cross-sections in the table
below:
Voltage
Cable Cross-
length
section
220 - 240V/ 50 Hz
Up to 50 m
1.5 mm
2
220 - 240V/ 50 Hz
50 - 100 m
2.5 mm
2
Assembling the handle :
7
4
5
B
9
6
0
A
A
1
7
8
z
m
1
2
6
7
7
4
3