Gardena 6000/3 S Operating Instructions Manual - 5. Trouble-Shooting
11
GB
5. Trouble-Shooting
Problem
Probable cause
Remedy
Pump is running,
Air cannot escape, since
Open pressure line (e.g. kinked
but doesn’t deliver.
pressure line is closed.
pressure pipe).
Air locks in suction base.
Wait for max. 60 seconds
until the pump deaerates auto-
matically over the vent valve.
Suction base
햵 clogged.
Clean suction base (see
point 4).
When starting the pump,
Submerge pump deeper
the water level faIls be-
(see min. submersion depth,
low the min. water level.
point 7).
Pump doesn’t start or
Thermal overload switch
Disconnect plug and clean
suddenly stops during
has switched the pump
turbine (see point 4). Observe
operation.
off due to overheating.
max. liquid temperature (35 °C).
No power.
Check fuses and electric
connections.
Pump runs, but output
Suction base clogged.
Clean suction base (see
suddenly decreases.
point 4).
If any other faults occur, please contact GARDENA Service.
6. After Operation
Putting into Storage:
➔ To protect the pump from frost damage, store the pump in a
dry place.
Disposal:
Unit may not be disposed of with normal household waste but
(in accordance with
must be disposed of in accordance with environmental
directive 20002/96/EC)
regulations.
www.devicemanuals.eu