Gardena AccuCut 400 Li Operating instructions manual - 3. Assembly
14
GB
3. Assembly
1. Push the cover
3
into the guide of the cutting head from
behind
2
until the connection locks into place on both sides.
2. Push plant guard
1
onto the cutting head from the front
2
until it locks into place.
20 plastic blades and a magazine for spare blades are supplied
with your trimmer. Up to 6 spare blades can be stored in the
magazine.
1. Slightly widen magazine
4
at open point and slide onto
handle
5
.
2. Insert up to 6 plastic blades
6
in the magazine
4
until the
blades jam.
To fit blade into blade carrier see 8. Troubleshooting
“Replacing blades”.
The additional wheel is available as an optional extra for the
AccuCut 400 Li. The additional wheel is already fitted on the
AccuCut 450 Li.
Fit additional wheel :
v
Fit additional wheel
7
onto the
guides of the handle holder
8
until you hear the connection
lock into place on both sides.
Remove additional wheel :
v
Pull both catches
9
out to the
side and remove the additional
wheel
7
from the guides of the
handle holder
8
.
Fold additional wheel up / down :
v
Press adjusting buttons
z
T
on both
sides, fold additional wheel up / down
7
and release the adjustment buttons
z
T
again.
Assembling the trimmer :
Fit additional wheel :
2
1
3
8
7
7
z
T
4
5
6
9
Only charge battery between 10 – 45 °C. After
heavy duty service allow battery to cool down
first.
Storage :
The trimmer must not be stored over 35 °C or
under direct exposure to sunlight.
Do not store the trimmer in places with static
electricity.
Fit magazine for
spare blades :