Gardena AccuCut Li 9851-20 Operation Instructions Manual - page 6
Electrical safety
Before use, examine cable for damage, replace it if there
are signs of damage or ageing.
If the replacement of the supply cord is necessary, this
has to be done by the manufacturer or his agent in order
to avoid a safety hazard.
Do not use the product if the electric cables are damaged
or worn.
Immediately disconnect from the mains electricity supply
if the cable is cut, or the insulation is damaged. Do not
touch the electric cable until the electrical supply has been
disconnected.
Always disconnect the mains cable before disconnecting
any plug, cable connector or extension cable.
Always wind cable carefully, avoiding kinking.
Use only on AC mains supply voltage shown on the
product rating label.
Under no circumstances should an earth be connected to
any part of the product.
Warning! This product makes an electromagnetic field
while it operates. This field may under some conditions
interfere with active or passive medical implants. To
decrease the risk of con ditions that can possibly injure or
kill, we recommend persons with medical implants to
speak with their physician and the medical implant
manufacturer before operating.
Cables
Use only permitted extension cables as per HD 516.
v
Ask your electrical specialist.
Personal safety
Always wear suitable clothing, protective gloves, and stout
shoes.
Thoroughly inspect the area where the product is to be
used and remove all wires and other foreign objects.
Before using the product and after any impact, check for
signs of wear or damage and repair as necessary.
If the product can no longer be switched off in the event
of a defect, place the product on a solid surface and moni-
tor until the battery is empty. Send the defective product to
the GARDENA Service Centre.
Never attempt to use an incomplete product or one with an
unauthorised modification.
Power tool use and care
Know how to stop the product quickly in an emergency.
Never hold the product by the guard.
Do not use the product if the protection equipments
(protective cover, quick blade-stop) are damaged.
Do not use ladders whilst operating the product.
Remove the battery:
– before leaving the product unattended for any period;
– before clearing a blockage;
– before checking, cleaning or working on the product;
– if you hit an object. Do not use your product until you are
sure that the entire product is in a safe operating condi-
tion;
– if the product starts to vibrate abnormally. Check
immedi ately. Excessive vibration can cause injury.
EN
22