Gardena Classic 3500/4E Operating Instructions Manual - 9. Available Accessories
Free the impeller:
z
An impeller blocked by dirt can be freed again.
v Turn motor shaft
z
using a screw driver.
This will free the blocked impeller.
For Art. no. 1758 only:
Cleaning the flow
sensor:
i
u
p
s
a
o
If the flow sensor is dirty, this may result in wrong error
messages (Info-LED).
1. Unscrew both screws
u
.
2. Remove the cover
i
.
3. Undo the screw
o
and detach the clip
p
.
4. Unscrew the cap
a
anticlockwise (e. g. by using a screwdriver).
5. Remove the impeller
s
and clean it. Clean the housing of the
flow sensor.
6. Re-fit the impeller
s
with the metal part in the mounting
direction.
7. Screw the cap
a
into place clockwise.
8. Secure the cap
a
by way of the clip
p
using the screw
o
.
9. First insert the cover
i
at the top and then tighten the
two screws
u
at the bottom.
For any other malfunctions please contact the GARDENA service department.
Repairs must only be carried out by GARDENA service departments or specialist
dealers authorised by GARDENA.
9. Available accessories
GARDENA Suction Hoses
Kink and vacuum-resistant, sold by the metre with 19 mm (3/4"),
25 mm (1") or 32 mm (5/4") diameter without fittings or in fixed
lengths Art. no. 1411 / 1418, complete with fittings, suction filter
and backflow preventer.
GARDENA Suction Hose
Fittings
For vacuum-resistant connection of the
pump to the suction hose sold by the metre.
Art. no.
1723 / 1724
Suction Filter with
Backflow Preventer
To equip suction hoses with Backflow
Preventer sold by the metre.
Art. no.
1726 / 1727
GARDENA Pump
Preliminary Filter
Recommended for pumping sandy water.
Art. no.
1730 / 1731
GARDENA Bore Hole
Suction Hose
For vacuum-resistant connection of the pump to
boreholes or pipe networks. Length 0.5 m. With
33.3 mm (G1) female thread at both ends.
Art. no. 1729
GARDENA Connection Set
Connection Set for 1/2" Pressure Hoses
Art. no. 1750
GARDENA Connection Set
Connection Set for 3/4" Pressure Hoses
Art. no. 1752
23
GB