Gardena HiCut 4019 Operating Instructions Manual - 9. Available Accessories
Repairs :
6
GB
The cutting gear of your cylinder mower was optimally adjusted
before leaving our company. If, after longer use, a clean cut of the
grass is no longer possible or the blade roller contacts the lower
blade, then the lower blade should be adjusted as follows:
1. Clean cylinder mower.
2. Check the cylinder
C
and lower blade
D
for notches and
remove these if necessary with a grinding stone.
3. Unscrew the hexagonal nuts
E
anticlockwise (e.g. with an
SW 10 mm hexagonal wrench) until the cylinder
C
turns
freely.
4. Turn the hexagonal nut
E
clockwise alternately left and
right gradually until the cylinder
C
and the lower blade
D
can hardly be heard touching each other.
5. Cutting test :
Place a strip of paper
F
on the lower blade
D
in such a way
that it points towards the spindle of the cylinder
C
.
6. Turn cylinder
C
carefully.
f the lower blade
D
is adjusted properly the paper will be cut
off as if with scissors.
7. Repeat the cutting test on the other blades
C
.
8. If the mower only cuts in the middle, each blade
C
must be
adjusted separately.
On safety grounds, only original GARDENA spares
A
may be used.
Please contact GARDENA Service if it is necessary to replace
the cutting tool, which will only become blunt after several years
use if well-maintained.
Have the cylinder mower checked over in the autumn if possible
so that it is ready for use immediately when the next lawn-mowing
season starts.
A
In the event of other faults please contact GARDENA Service.
Repairs should only be carried out by GARDENA service centres or dealers
authorised by GARDENA.
9. Available accessories
GARDENA Grass Catcher
Saves raking up the cut grass.
Art. 964.90.10 - 30
Readjusting the
cutting mechanism :
C
E
C
F
D