Gardenline 31CC 4 STROKE User Manual - Aa.
Understanding and using these operating instructions
31cc Brushcutter / Line Trimmer
AFTER SALES SUPPORT
e-mail: help@powertoolsupport.com
1800 909 909
MODEL: №. WLBCF310 • 08/2015 • 49290
(toll free)
Operating instructions and safety notes!
AFTER SALES SUPPORT
(toll free)
31cc Brushcutter / Line Trimmer
e-mail: help@powertoolsupport.com
1800 909 909
MODEL: №. WLBCF310 • 08/2015 • 49290
19
Fitting & Adjusting the Double Strap Shoulder Harness
WARNING. The Double strap shoulder harness (31) must be fitted
before use of the product.
This includes both combinations of the brushcutter or the line trimmer.
1. Place the shoulder straps over each shoulder so that the 2 padded shoulder
straps are located on your front side (Fig. V), with the square black plastic
support where the straps interweave, located on your back. (Fig. W)
2. Connect the clip at the front to secure the
double strap shoulder harness (31) into position
on your body. (Fig. X) NOTE: The side pad guard
will be located on your right hand side.
3. To adjust the double shoulder strap harness (31)
on your body, tighten or loosen the front straps
adjusters. (Fig. Y)
4. Ensure the metal connector clip is attached
onto the side pad guard correctly. When in the
correct position, the long metal tab (as shown in
Fig. Z with the arrow on it) needs to be holding
the metal connector clip in place.
5. To attach to the unit, insert the clip on the side
pad guard through the double strap shoulder
harness attachment point (37) (Fig. AA )
The location of the side pad guard can also be
changed by tightening or loosening the adjuster
on the side pad guard.
The double shoulder strap harness (31) is fitted with
a quick release clip which allows rapid removal of
the appliance from the harness.
To activate the quick release clip so as to remove
the appliance, “Pull the red tab thus withdrawing
the metal tab”. The attaching clip will then release
from the harness.
W.
V.
X.
Y.
AA.
Z.