Gardenline 31CC 4 STROKE User Manual - Tips For Operation
Understanding and using these operating instructions
31cc Brushcutter / Line Trimmer
AFTER SALES SUPPORT
e-mail: help@powertoolsupport.com
1800 909 909
MODEL: №. WLBCF310 • 08/2015 • 49290
(toll free)
22
Operating instructions and safety notes!
AFTER SALES SUPPORT
(toll free)
31cc Brushcutter / Line Trimmer
e-mail: help@powertoolsupport.com
1800 909 909
MODEL: №. WLBCF310 • 08/2015 • 49290
Tips for Operation
Always use the double shoulder strap harness (31) when using the
brushcutter to avoid serious personal injury.
Hold the brushcutter with one hand on the trigger handle and the other
hand on the J handle (12). Keep a firm grip with both hands while in
operation. The brushcutter should be held at a comfortable position with
the double shoulder strap attachment point (31) about hip height.
Maintain your grip and balance on both feet. Position yourself so that you
will not be drawn off balance by the kick-back reaction of the 3T brushcutter
blade (28).
When using the double shoulder strap harness (31), adjust to position the
double shoulder strap attachment point (37) on the brushcutter at
approximately hip height.
Exercise extreme caution when using the 3T brushcutter blade (28) with
this unit. Blade thrust is the reaction which may occur when the spinning
3T brushcutter blade (28) contacts anything it cannot cut. This contact may
cause the 3T brushcutter blade (28) to stop for an instant, and suddenly
“thrust” the unit away from the object that was hit.
This reaction can be violent enough to cause the operator to lose control of
the unit. Blade thrust may occur without warning if the blade snags, stalls or
binds. This is more then likely to occur in areas where it is difficult to see the
material being cut.
For cutting ease and safety, approach the weeds being cut from the right to
the left. In the event that an unexpected object or woody stock is
encountered, this could cause the blade thrust reaction.
Specific Assembly for use as a Line Trimmer
Fitting the Clip-on Guard Attachment to the Line trimmer
NOTE: Always ensure the engine is turned off before undertaking this task.
Always use the double shoulder strap harness (31) when using the line
trimmer to avoid serious personal injury.
NOTE: the clip-on line trimmer guard attachment (33) must be secured to
the brushcutter guard (17) before ANY line trimming work is undertaken.
NOTE: Always ensure the engine is turned off before undertaking
this assembly.