Gardenline GLPC 40 User Manual - After Sales Support
AFTER SALES SUPPORT
1300 922 271
MODEL NUMBER: GL-CT 36 Li, 02/14
11
service.australia@isc-gmbh.info
Protection from environmental influences
1.
Wear suitable work clothes. Wear safety
goggles.
2.
Protect your cordless tool and the battery
charger from moisture and rain. Moisture and
rain can cause dangerous cell damage.
3.
Do not use the cordless tool or the battery
charger near vapors and inflammable liquids.
4.
Use the battery charger and cordless tools only
in dry conditions and an ambient temperature
of 10-40°C.
5.
Do not keep the battery charger in places where
the temperature is likely to reach over 40°C. In
particular, do not leave the battery charger in a
car that is parked in the sunshine.
6.
Protect batteries from overheating. Overloads,
over-charging and exposure to direct sunlight
will result in overheating and cell damage.
Never charge or work with batteries which have
been overheated – replace them immediately if
possible.
7.
Storage of batteries, battery chargers and
cordless tools. Store the charger and your
cordless tool only in dry places with an
ambient temperature of 10-40°C. Store your
lithium-ion battery pack in a cool, dry place at
a temperature of 10-20°C. Protect them from
humidity and direct sunlight. Only place fully
charged batteries in storage (charged at least
40%).
8.
Prevent the lithium-ion battery pack from
freezing. Battery packs which were stored
below 0°C for more than 60 minutes must be
disposed of.
9.
When handling batteries beware of electrostatic
charge: Electrostatic discharges cause damage of
the electronic protection system and the battery
cells. Avoid electrostatic charging and never
touch the battery poles.
Batteries contain substances harmful to the
environment. Never place batteries in your
household refuse, in fire or in water. Batteries
should be collected, recycled or disposed of in an
environmentally friendly way. Seek advice on correct
disposal from local waste authorities.
Do not lose this safety information.
Layout (Fig. 1/2)
2
1.
Battery
2.
Safety lock-off
3.
On/Off switch
4.
Additional handle
5.
Height adjustment
6.
Shaft
7.
Button for angle adjustment
8.
Safety hood
9.
Flower guard
10. Line spool
11. Charger
12. Pushbutton for battery indicator
13. Battery indicator
Items Supplied
3
•
Open the packaging and take out the
equipment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until the
end of the guarantee period.