Gardenline GLPC 40 User Manual - After Sales Support
AFTER SALES SUPPORT
1300 922 271
MODEL NUMBER: GL-CT 36 Li, 02/14
13
service.australia@isc-gmbh.info
6.2 Installing the additional handle (Fig. 4)
Undo the securing screw from the handle and then
place the handle on the main handle (Fig. 4) and
secure it with the screw.
6.3 Adjusting the line (Fig. 7)
Important! Remove the battery from the tool
before doing any work.
To adjust the length of the line, push the button
as shown in Fig. 7 and pull the line slowly. Repeat
pushing the button till the line has the required
length.
6.4 Height adjustment (Fig. 5)
Undo the lever (Fig. 5/Item b) until the grass trimmer
handle can be moved in and out freely. Now set the
required working height and secure in this position
by tightening the lever (b) again.
6.5 Battery (Fig. 2a/ Item 11)
The equipment is fitted with a lithium-ion
battery. The battery pack is completely closed and
maintenance free.
6.5.1 Battery charge level indicator (Fig. 2a)
The battery pack is equipped with a pushbutton
for checking the charge level. Simply press the
pushbutton (Figure 2a/Item 13) to read off the
battery level from the LEDs of the battery indicator
(Fig. 2b/ Item 14):
•
All 3 level monitoring LEDs are lit:
Battery charge level is high.
•
2 level monitoring LEDs are lit: Battery charge
level is decreasing. Stop work as soon as
possible.
•
1 level monitoring LED is lit: Battery is flat. Stop
work IMMEDIATELY and charge the battery.
Otherwise the battery’s service life will be
greatly shortened.
6.5.2 Charging the battery
•
Pull the pushlock button (Fig. 6/ Item c) and pull
the battery pack (11) out of the equipment as
shown in Fig. 6.
•
Check that your mains voltage is the same as
that marked on the rating plate of the battery
charger. Insert the power plug of the charger
into the mains socket outlet. The LED A (Fig. 2b)
will then illuminate in green.
•
Push the battery onto the charger as shown in
Fig. 2a. The LED B will illuminate in red while
LED A is still green (Fig. 2b).
•
The battery is fully charged when LED A and B
(Fig. 2b) are illuminated in green.
•
Pull the pushlock button (Fig. 2a/ Item c) and
pull the battery pack (11) out of the charger.
•
Place the recharged battery into the equipment
as shown in Fig. 6
If the rechargeable battery pack fails to charge, check
whether there is voltage at the socket outlet.
If you still fail to charge the battery pack, please call
our customer service center on 1300 922 271.
Timely recharging of the battery will help it serve
you well for a long time. You must recharge the
battery pack when you notice that the power of the
equipment drops.
Never allow the battery pack to become fully
discharged. This will cause it to develop a defect.
Operations
7
Your grass trimmer will work at its best if
you observe the following instructions:
•
Never use the grass trimmer without its safety
devices.
•
Do not cut grass when it is wet. The best results
are had on dry grass.
•
To switch on your grass trimmer, press the
safety lock-off (Fig. 1/ Item 2) and the ON/OFF
switch (Fig.1/ Item 3).
•
To switch off your grass trimmer, let go of the
•
ON/OFF switch (Fig. 1/ Item 3).
•
Do not move the grass trimmer against the
grass until the switch is pressed, i.e. wait until
the trimmer is running.
•
For the correct cutting action, swing the grass
trimmer to the side as you walk forward,
holding it at an angle of approx. 30° as you do
so (see Figure 8-9).
•
Make several passes to cut long grass shorter
step by step from the top (see Figure 10).
•
Use the safety guard to prevent unnecessary
wear.
•
To avoid unnecessary wear, keep the grass
trimmer away from hard objects.
Using the grass trimmer as an edge trimmer
•
The grass trimmer can be adjusted as follows to
trim the edge of lawns and beds.
•
Remove the battery.
•
Press the setting button (Fig. 11 / Item 7) and
turn the top handle through 180° until it locks.
•
The grass trimmer can thus be adjusted for use
as an edge trimmer for making vertical cuts on
on the grass (Fig. 12).