Gardenline GPHS-26cc User Manual - page 7
Gardenline
07
26
Gardenline
•
Clean dirt from the grease fitting (A).
•
Carefully pump grease into fitting (A). Do not force grease. Too much pressure will force
grease past seals and cause damage. Apply 1-2 pumps of grease every 15-25 hours of
operation.
•
Wipe excess grease from around grease fitting.
Sharpening blades (Level 3)
Fig. 39 - 41
Tools required:
2
Wrenches, 10 mm
1
Flat file
1
Screwdriver
Parts required:
None
Warning! Hedge Trimmer Blades are very sharp. Wear gloves to protect hands.
•
Disconnect spark plug wire.
•
Remove blade stiffener (see “Blade Stiffener Remove/Install instructions”).
•
Slide blades to allow file clearance using slots (A) on bottom of blade. Do not pry against
cutting edges.
•
File each edge carefully. Follow the original shape of the blade.
Important:
If a power grinder is used do not allow blade to over heat.
•
Install blade stiffener (see “Blade Stiffener Remove/Install instructions”).
•
Lubricate blades (see “Lubrication instructions”).
Important:
Blades should only be removed and reinstalled by an authorized Servicing
address, otherwise premature wear or internal damage may occur.
GB
Fig.28
Fig.29
Fig.30
Fig.31
Fig.32
Fig.33