Gardenline GPHS-26cc User Manual - page 8
Gardenline
25
Parts required
None.
High altitude adjustment is not required for proper operation of this engine.
Note:
Every hedge trimmer is run at the factory and the carburetor is set in compliance with
emission regulations. This carburetor does not have acceleration and high-speed adjustment
needles.
Check idle speed and reset if necessary. If a tachometer is available, idle speed screw (A)
should be set to the specifications found in “Specifications” part of this manual. Turn idle
screw (A) clockwise to increase idle speed; counter clockwise to decrease idle speed.
Warning! When carburetor adjustment is completed, the cutting attachment
should not move at idle, otherwise serious personal injury may result.
Lubricating blades (Level 1)
Fig. 34 - 36
Tools required:
1
Clean rag
1
Cleaning brush, 25 mm or 50 mm (1” or 2”)
Parts required:
1
Engine Oil, 20 W (lubrication)
1
Mixture of kerosene and 20W oil, 50-50 (cleaning).
Warning! Hedge Trimmer blades are very sharp. Wear gloves to protect hands.
•
Disconnect spark plug wire from spark plug.
•
Brush loose debris from blade and coat both sides of blade with the 50-50 cleaning
mixture.
•
Allow cleaning mixture to soften the remaining gummy residue then wipe it from the blade.
•
Apply clean oil to the entire length of the blade. Be certain the blade bolts are lubricated.
•
Wipe excess oil from the blade before putting the hedge trimmer back in service.
Lubricating gear box assembly (Level 1)
Fig. 37 - 38
Tools required:
1
Grease Gun
1
Clean rag
Parts required:
1
Grease , 14 oz. or Lithium based
GB
08
Gardenline
Fig.34
Fig.35
Fig.36
Fig.37
Fig.38
Fig.39