Gardenline LT26 User Manual - Maintenance
S
U
A
1800 909 909
www.globalpowerbrands.com email: help@globalpowerbrands.com
AFTER SALES SUPPORT
43670
20
9. With the spring fitted onto the shaft of the spool holder insert
the spool back into the holder. As you insert the spool, thread
the lines through the eyelets and pull firmly to disengage from
the notch in the spool.
Note.
When inserting the spool into the housing, the spool
may need to be rotated slightly so as to locate into the
housing. Before the spool is fully inserted into the housing,
ensure the lines are free of the notches.
10.Once the spool is fully inserted and the lines are fully through
the eyelets, pull firmly on each line to disengage the lines from
the spool notches. Ensure the lines are fully clear of the spool
notches and the line is passing through the eyelets directly to
the spool.
11.To install the spool, line and housing, refer to
‘Fitting the
spool
’ section of this manual.
Note.
On start up test the operation of the bump feed to ensure the line feeds
correctly.
CAUTION.
After changing the line spool, run the petrol line trimmer under
no load for at least a minute to make sure that the line and the tool are
both operating correctly. Use only the line spool as recommended by the
manufacturer.
WARNING.
Never use steel threads and/or three teeth blade other than those
provided by the manufacturer. Always use tools in perfect condition, free of
damage.
WARNING.
In high-speed rotation, parts could be projected at very high speed
and could involve serious injury and damages to persons and property.
Maintenance
Air filter
Accumulated dust in the air filter will reduce engine efficiency. Increase fuel
consumption and allow abrasive particles to pass into the engine. Remove the
air filter as often as necessary to maintain a clean condition.
• Remove filter cover (12) by pressing in the sides and lifting it off.
• Light surface dust can readily be removed by tapping the filter.
5