G g g g a a a a rr rr d d d d tt tt e e e e c c c c 3 3 3 3 7 7 7 7 0 0 0 0 5 5 5 5 8 8 8 8 1 1 1 1 // // 5 5 5 5 8 8 8 8 2 2 2 2 user instructions user.Qxd 09/03/00 13:16 page 1.
User manual introduction welcome to the gardte been programmed to s you will have been left will allow you to progra with the control panel. Not familiar with the te on page 13. Keypads control of the system four remote key pads m to carry out all operatio if the keypad alert key by pressing and hol...
User manual the flow chart shown b used to access the sys enter master code press no press no press no reset if programmed by the engineer allows the system to be reset after an alarm. Remove set the system with one or more zones (selected by the master user) removed. Test allows the system to be te...
User manual removing zone with the system unset enter master code an no until screen flashe to unset system or a during exit re-enter c note: to "un that ma remove enter th then no section page 4 setting and unsetting the system with the system unset (display showing 'un') enter a master code and sc...
User manual viewing the log with the system unset enter master code an no until screen flashe page 6 testing the system with the system unset enter master code and press no until screen flashes:- whilst in this mode any zones activated will generate a tone and be displayed. Pressing 9 whilst in this...
User manual changing code with system unset enter master code an no until screen flashe notes: to delete a code ente new code. User 1 (master code) changed it cannot be user levels are:- user 1 = master use user 2 = user level user 3 = set only le user 4 = master leve user 5 = master leve user 6 = u...
User manual display messag the following system '1 to 6 or 7' 'r1' 't' 'ca' 'fb' 'bb' 'cb' 'ct' 'pc' 'ac' display messag 'un' 'e ' 'e ' 'e ' 'e ' ' ' ' ' ' ' ' ' 'al ' page 10 resetting after an alarm one of four reset modes may have been programmed by your engineer. Any code the system will reset t...
User manual glossary of ter full set part set 1, 2 or 3 unset reset remove test log chime user codes zone abort display messages (log) apart from the system and status displays the following messages may also appear whilst viewing the log. 's ' system full set 's ' system part 1 set 's ' system part...
