GARDINER TECHNOLOGY Gardtec 370 581 User Instructions - Removing Zone
USER MANUAL
Removing Zone
With the system Unset
Enter Master code an
NO until screen flashe
To unset system or a
during exit Re-enter c
Note:
To "Un
that ma
remove
Enter th
then NO
section
Page 4
Setting and Unsetting the System
With the system Unset (display showing 'Un') enter a
Master code and screen will flash
OR
With system Unset enter
code other than Master
(eg User code) & system
will start to Set then:-
Whilst the system is
setting.
Press 1 to Part 1
Set the system.
Press 2 to Part 2
Set the system.
Press 3 to Part 3
Set the system.
To Unset the system
enter premises via
authorised route
and enter code.
System fully set
System set
Part 1 Removed
System set
Part 2 Removed
System set
Part 3 Removed
If YES was Pressed
If 1 was Pressed
If 2 was Pressed
If 3 was Pressed
To abort setting during exit
Re-enter code.
Note:
When the system
starts to set a short
delay will be noticed
before the exit
sounder is activat-
ed. This delay
allows lower levels
of codes to silent
part set the system
without the exit
sounder operating.
User.QXD 09/03/00 13:16 Page 6