Garland BH/BA 1500 Installation And Operation Manual - Operation Continued
Part # 4520899 Rev 1 (09/04/08)
Page 12
• Donotinsertanypieceofpaper,cardboard,cloth,etc.
between the pan and the heating area, as this might
initiate a fire.
• Sincemetallicobjectsareheatedupveryquicklywhen
placed on the heating area, do not place any other
objects (closed cans, aluminium foil, cutlery, jewelry,
watches etc.) on the induction cooker.
• Personswithapacemakershouldconsulttheirdoctor
whether they are safe near an induction cooker.
• Aluminiumfoilandplasticvesselsmustnotbeplacedon
the hot surface.
• Thesurfacemustnotbeusedforstorage.
• Donotplacecreditcards,phonecards,cassettetapes,or
other objects sensitive to magnetism on the Ceran glass.
• Theinductioncookerhasaninternalair-coolingsystem.
Do not obstruct the air inlet- and air outlet-slots with
objects (cloth). This would cause overheating and
therefore the cooker would switch off.
• Avoidliquidenteringintothecooker.Donotletwateror
food overflow the pan. Do not clean the cooker with a jet
of water.
• Iftheheatingarea(Ceranglass)iscrackedorbroken,the
induction cooker must be switched off and disconnected
from the electric connection. Don’t touch any parts inside
the cooker.
• Donotusepanswithanunevenbottom.
• Ifthesupplycordisdamaged,itmustbereplacedbythe
manufacturer, the service agent or a similarly qualified
person in order to avoid a hazard.
OPERATION continued
Unauthorized Reconstruction
And Use Of Spare Parts
Reconstruction of the cooker or changes to the cooker are
not allowed. Contact the manufacturer if you intend to
make any changes on the cooker. To guarantee safety, use
only genuine spare parts and accessories authorized by the
manufacturer. The use of other components will void all
warranty.
Improper Operating Methods
The operating reliability of the cookers can only be
guaranteed by careful use.
Pan Detection
Pans having a diameter less than 4.72” (120 mm) are not
detected. During pan detection, the indicator operation
flashes. No power is transferred and the indicator lamp
flashes if no pan or an unsuitable pan is detected.
Control Of The Heating Area
The heating area is controlled by a temperature sensor.
Overheated pans (hot oil, empty pans) can be detected.
Energy transfer will be stopped. The induction unit must be
re-started after it has cooled down.