Garland Mealstream 501 Installation And Operating Instructions Manual - page 14
14
RUNNING A PROGRAM
Using number pad keys to run a program
Programs 01 to 99 can be recalled using the number pad keys.
The following procedure should be used to activate these programs.
Pre-heat the oven to the required starting temperature by
pressing a TEMPERATURE SETTING PAD. Wait until the
selected temperature light stops flashing.
You can check the oven temperature by
pressing the Temperature pad again
Press the PROGRAM PAD the ‘P’ will
appear in the PROGRAM DISPLAY.
Avoiding contact with hot surfaces. Place the
food item to be cooked in to the oven and
close the door.
Press the number pad key you wish to activate (01-99)
The program number and total cooking time appear on
the display and the first stage indicator will light.
The program will now operate with the
total remaining time displayed counting
down on the display
(all stage time added together).
When the time reaches “00:00” an
audible signal will be given.
Remove the food from the oven and close the door.
Programs can be halted
and cancelled at any time
by pressing the CANCEL
key.
To continue the program
press any
TEMPERATURE
SETTING pad.
CALL BACK
CALL BACK to review a program allows the program to be reviewed stage
by stage.
Press and hold the CANCEL PAD.
After a few seconds the TIME
DISPLAY will blank.
Now press a program number on
the NUMBER PAD (01-99).
Note:
If the required starting
temperature has not
been reached, an error
code is displayed (E:6).
If this happens remove
food from the oven
IMMEDIATELY and
wait until the required
temperature light stops
flashing. Begin again
from Step 2.
At the end of the
programmed cycle,
the oven temperature
will revert to that set
before the cycle began
example: 400°F
example: Program 08
The display will show the contents of that program. This will be shown with
temperature, time and power level illuminated one stage at a time for a few
seconds.
To review a program
use callback
1
2
3
4