Garland MWE-9501 Operation Manual - page 24
1. PRESS and HOLD the “PROG” button for five, (5),
seconds. (Display will flash GC450 and the program
version number).
2. PRESS the “PROG” button twice to display “SYSTEM
SETUP”.
3. PRESS the “MENU” button to display “DISPLAY
TEMP. IN : ºF/ºC”.
4. PRESS the “UP ARROW” button ( ↑ ) to change ºF or
ºC.
5. PRESS the “PROG” button to display “SYSTEM
SETUP”.
6. PRESS the “RIGHT ARROW” button (→) to return to
the normal OPERATING MODE.
1. PRESS and HOLD the "PROG" button for five, (5),
seconds. (Display will flash GC450 and the program
version number).
2. PRESS the "PROG" button twice to display "SYSTEM
SETUP".
3. PRESS and HOLD the "UP ARROW" ( ↑) button for
ten, (10), seconds, "GAP CALIBRATION" will be
displayed.
4. PRESS the "UP ARROW" button ( ↑ ) again, the "+"
(PLUS) button to increase the value OR the "RIGHT
ARROW" button (→), "-" (MINUS) to decrease the
value.
5. PRESS the "PROG" button to display "SYSTEM
SETUP".
6. PRESS the "RIGHT ARROW" button (→), to return
to the normal OPERATING MODE.
24
1. PRESS and HOLD the “PROG” button for five, (5),
seconds. (Display will flash GC450 and the program
version number).
2. PRESS the “PROG” button twice to display “SYSTEM
SETUP”.
3. PRESS the “MENU” button to display “ALARM
VOLUME”.
4. PRESS the “UP ARROW” button ( ↑ ) to change
(HIGH/LOW).
5. PRESS the “PROG” button to display “SYSTEM
SETUP”.
6. PRESS the “RIGHT ARROW” button (→) to return
to the normal OPERATING MODE.
1. PRESS and HOLD the “PROG” button for five, (5),
seconds. (Display will flash GC450 and the program
version number).
2. PRESS the “PROG” button twice to display “SYSTEM
SETUP”.
3. PRESS and HOLD the “UP ARROW”( ↑) button for
ten, (10), seconds, “GAP CALIBRATION” will be
displayed.
4. PRESS the “MENU” button. The hold feature will
display “OFF”.
5. HOLD the “RIGHT ARROW” (→) for ten, (10),
seconds, the “OFF WILL FLASH”.
6. PRESS the “UP ARROW” ( ↑) to change the safety
(ON/OFF).
7. PRESS the “PROG” button to display “SYSTEM
SETUP”.
8. PRESS the “RIGHT ARROW” button (→) to return to
the normal OPERATING MODE.
PROGRAMMING
To Enable / Disable Start Delay
To Change the Gap Calibration
To Change the Speaker Volume (High / Low)
To Display Temperatures in F or C
SYSTEM SETUP