1. DL manuals
  2. Garmin
  3. GPS
  4. GPS 100
  5. Installation Manual

Garmin GPS 100 Installation Manual

Other manuals for GPS 100: Owner's Manual
Manual is about: Garmin GPS 100 Personal Navigator Owner's Manual

Summary of GPS 100

  • Page 1

    Av. Kit install. Manual 190-00004-00 rev. G page 1 gps100 aviation kit installation manual communication & navigation sm garmin international, inc. Part number: 190-00004-00 9875 widmer road revision g, 15 october 1992 lenexa, kansas 66215.

  • Page 2

    Av. Kit install. Manual 190-00004-00 rev. G page 2 © copyright 1992 garmin international, inc. All rights reserved this publication is the proprietary property of garmin international inc. It may not be reproduced or transmitted in any form whether printed or electronic, without the expressed writte...

  • Page 3

    Av. Kit install. Manual 190-00004-00 rev. G page 3 gps 100 aviation kit installation manual table of contents section 1 general description 1.1 introduction 1.2 technical characteristics 1.2.1 physical characteristics 1.2.2 operational characteristics 1.2.3 interfaces section 2 installation consider...

  • Page 4

    Av. Kit install. Manual 190-00004-00 rev. G page 4 list of illustrations figure 1-1 aviation rack pinout definition 1-2 interconnect schematic 2-1 antenna installation considerations 2-2 gps installation considerations 3-1 blade antenna installation 3-1a low profile antenna installation 3-2 coax cab...

  • Page 5

    Av. Kit install. Manual 190-00004-00 rev. G page 5 section 1 general description 1.1 introduction this manual describes the physical, mechanical, and electrical characteristics and the installation requirements for the gps 100 aviation kit. After installation of the gps 100 system, faa form 337 must...

  • Page 6

    Av. Kit install. Manual 190-00004-00 rev. G page 6 1.2.3 interfaces the aviation rack contains an electronic module which provides interfaces to various general aviation instruments. Figure 1-1 defines the function of each pin on the 15 pin dsub connector located at the back of the rack. Figure 1-2 ...

  • Page 7

    Av. Kit install. Manual 190-00004-00 rev. G page 7 2.1.2 noise sources the antenna should be located at least 3 ft from transmitting antennas such as vhf comm, hf transmitter, dme, transponder, and radar. Cabling for the gps 100 should not be routed near components or cabling which are sources of el...

  • Page 8

    Av. Kit install. Manual 190-00004-00 rev. G page 8 section 3 installation procedure 3.1 installation kit contents one of the following two installation kits is required for aircraft installation, depending on the type of antenna used. The gps 100 aviation installation kit (010-10002-00) consists of ...

  • Page 9

    Av. Kit install. Manual 190-00004-00 rev. G page 9 3.2 antenna installation the blade antenna outline and footprint dimensions are shown in figure 3-1. The low profile antenna outline and footprint dimensions are shown in figure 3-1a. Both antennas require the same installation procedure. A. Using t...

  • Page 10

    Av. Kit install. Manual 190-00004-00 rev. G page 10 3.5 aviation interface set-up before installing the gps 100 into the aviation rack, several operating parameters need to be set-up so that the gps 100 can interface properly with the aviation rack and other avionics. Press the on button. The initia...

  • Page 11

    Av. Kit install. Manual 190-00004-00 rev. G page 11 with power applied to the aviation rack turn the gps 100 on. The self-test page will be displayed followed by the initialization page. The gps 100 must be properly set- up per the instructions in section 3.5 before performing the checkout procedure...

  • Page 12

    Av. Kit install. Manual 190-00004-00 rev. G page 12 figure 1-1 av. Rack pinout definition.

  • Page 13

    Av. Kit install. Manual 190-00004-00 rev. G page 13 figure 1-2 interconnect schematic.

  • Page 14

    Av. Kit install. Manual 190-00004-00 rev. G page 14 f:\antplace.Cdr antenna must be on top of aircraft. Antenna masked by vertical fin, t tail, or dorsal fin ok fig 2-1 antenna installation considerations maintain 6"(16 cm) compass safe distance unit to be mounted in aircraft radio rack as high as p...

  • Page 15

    Av. Kit install. Manual 190-00004-00 rev. G page 15 figure 3-1 blade antenna installation.

  • Page 16

    Av. Kit install. Manual 190-00004-00 rev. G page 16 figure 3-1a low profile antenna installation.

  • Page 17

    Av. Kit install. Manual 190-00004-00 rev. G page 17 figure 3-2 coax cable installation.

  • Page 18

    Av. Kit install. Manual 190-00004-00 rev. G page 18 figure 3-3 aviation rack dimensions.

  • Page 19

    Av. Kit install. Manual 190-00004-00 rev. G page 19 figure 3-4 aviation rack installation.

  • Page 20

    Av. Kit install. Manual 190-00004-00 rev. G page 20 this page was intentionally left blank..

  • Page 21

    Av. Kit install. Manual 190-00004-00 rev. G page 21 appendix a installation details for beech b60 1.0 introduction: this appendix provides airframe specific information which is necessary to install the garmin gps 100 navigation system in the beech duke model b60 in accordance with stc (tbd). When s...

  • Page 22

    Av. Kit install. Manual 190-00004-00 rev. G page 22 2.4 placards after completion of the gps 100 system installation, affix a durable placard on the instrument panel in the location shown in figure a-3 which states “gps limited to vfr use only". Garmin placard p/n 161-00024-00 or an appropriate equi...

  • Page 23

    Av. Kit install. Manual 190-00004-00 rev. G page 23 fig a-1 functional block diagram.

  • Page 24

    Av. Kit install. Manual 190-00004-00 rev. G page 24 fig a-2 fuselage stations and weight and balance data.

  • Page 25

    Av. Kit install. Manual 190-00004-00 rev. G page 25 fig a-3 panel layout.

  • Page 26

    Av. Kit install. Manual 190-00004-00 rev. G page 26 fig a-4 wiring diagram.

  • Page 27

    Av. Kit install. Manual 190-00004-00 rev. G page 27 fig a-5 breaker locations.