1. DL manuals
  2. Garmin
  3. GPS
  4. GPS 150
  5. Installation Manual

Garmin GPS 150 Installation Manual

Other manuals for GPS 150: Pilot's Manual
Manual is about: Garmin GPS 150: Owners Manual

Summary of GPS 150

  • Page 1

    Av. Kit install. Manual 190-00026-00 rev. Q page 1 gps 150 installation manual garmin international, inc. Part number: 190-00026-00 1200 e. 151st street revision q, 3 april 1998 olathe, kansas 66062-3426.

  • Page 2

    Av. Kit install. Manual 190-00026-00 rev. Q page 2 © copyright 1992-1998 garmin corporation all rights reserved this publication is the proprietary property of garmin international inc. It may not be reproduced or transmitted in any form whether printed or electronic, without the expressed written c...

  • Page 3

    Av. Kit install. Manual 190-00026-00 rev. Q page 3 table of contents section 1 general description 1 . 1 introduction 1 . 2 technical characteristics 1 . 2 . 1 physical characteristics 1 . 2 . 2 operational characteristics 1 . 2 . 3 interfaces section 2 installation considerations 2 . 1 antenna cons...

  • Page 4

    Av. Kit install. Manual 190-00026-00 rev. Q page 4 list of illustrations figure 1 - 1 pinout definition 1 - 2 interconnect schematic 2 - 1 antenna installation considerations 2 - 2 gps installation considerations 3 - 1 stud mount ga 56 installation 3 - 2 flange mount ga 56 installation 3 - 3 coax ca...

  • Page 5

    Av. Kit install. Manual 190-00026-00 rev. Q page 5 section 1 general description 1.1 introduction this manual describes the physical, mechanical, and electrical characteristics and the installation requirements for the gps 150 aviation kit. After installation of the gps 150 system, faa form 337 must...

  • Page 6

    Av. Kit install. Manual 190-00026-00 rev. Q page 6 nav flag: capable of driving up to three 1000 ohm parallel (pins 3 and 4) loads, 375 millivolts for flag out-of-view, and +40 millivolts for flag in-view. Obi data: output providing bearing to waypoint data for a (pins 7, 8, and 23) bendix/king rmi ...

  • Page 7

    Av. Kit install. Manual 190-00026-00 rev. Q page 7 section 2 installation considerations careful planning and consideration of the suggestions in this section are required to achieve the desired performance and reliability from the gps 150. 2.1 antenna considerations 2 . 1 . 1 satellite visibility t...

  • Page 8

    Av. Kit install. Manual 190-00026-00 rev. Q page 8 2) replace or clean vhf comm rack connector to assure good coax ground. 3) place a grounding brace between the gps 150, vhf comm, and ground. 4) shield the vhf comm wiring harness. 2.2 rack considerations 2 . 2 . 1 accessibility plan a location whic...

  • Page 9

    Av. Kit install. Manual 190-00026-00 rev. Q page 9 section 3 installation procedure 3 . 1 installation accessories the following installation accessories are available: antenna and rack options 0 1 0 - 1 0 0 4 0 - 0 1 ga 56 low profile antenna kit (stud-mount ga 56 antenna, mounting hardware, no cab...

  • Page 10

    Av. Kit install. Manual 190-00026-00 rev. Q page 10 with sealant. Insure that the mounting screws are fully tightened and that the antenna base is well seated against the gasket. Caution: do not use construction grade rtv sealant or sealants containing acetic acid. These sealants may damage the elec...

  • Page 11

    Av. Kit install. Manual 190-00026-00 rev. Q page 11 3 . 4 rack installation a. Figure 3-4 shows outline dimensions for the aviation rack. Install the rack in a rectangular 6.320" x 2.000" hole in the instrument panel. Exercise caution when installing the rack into the instrument panel. The rack is d...

  • Page 12

    Av. Kit install. Manual 190-00026-00 rev. Q page 12 with power applied to the aviation rack and the gps 150 unit off, continuously depress the ent key and turn the unit on (release the ent key when the display activates). Rotate the outer knob, and the cdi test page will be displayed. Using the cont...

  • Page 13

    Av. Kit install. Manual 190-00026-00 rev. Q page 13 arrival o f f ensure the arrival annunciator is off o n ensure the arrival annunciator is on select the power test page by removing the cursor from the annunciator test page and turning the outer knob one detent to the right. Verify the following s...

  • Page 14

    Av. Kit install. Manual 190-00026-00 rev. Q page 14 figure 1-1 pinout definition.

  • Page 15

    Av. Kit install. Manual 190-00026-00 rev. Q page 15 figure 1-2 interconnect schematic.

  • Page 16

    Av. Kit install. Manual 190-00026-00 rev. Q page 16 maintain 6"(16 cm) compass safe distance fig 2-2 gps installation considerations fig 2-1 antenna installation considerations antenna masked by vertical fin, t tail, or dorsal fin antenna must be on top of aircraft. Ok.

  • Page 17

    Av. Kit install. Manual 190-00026-00 rev. Q page 17 fig 3-1 stud mount ga 56 antenna installation.

  • Page 18

    Av. Kit install. Manual 190-00026-00 rev. Q page 18 figure 3-2 flange mount ga 56 antenna installation.

  • Page 19

    Av. Kit install. Manual 190-00026-00 rev. Q page 19 figure 3-3 coax cable installation.

  • Page 20

    Av. Kit install. Manual 190-00026-00 rev. Q page 20 figure 3-4 aviation rack dimensions.

  • Page 21

    Av. Kit install. Manual 190-00026-00 rev. Q page 21 figure 3-5 aviation rack installation.

  • Page 22

    Av. Kit install. Manual 190-00026-00 rev. Q page 22 appendix a installation details for beech v35b 1 . 0 introduction this appendix provides airframe specific information which is necessary to install the garmin gps 150 navigation system in the beech bonanza model v35b in accordance with stc sa00066...

  • Page 23

    Av. Kit install. Manual 190-00026-00 rev. Q page 23 2 . 4 placards after completion of the gps 150 system installation, affix a durable placard on the instrument panel in the location shown in figure a-3 which states “gps limited to vfr use only". Garmin placard p/n 161-00024-00 or an appropriate eq...

  • Page 24

    Av. Kit install. Manual 190-00026-00 rev. Q page 24 fig a-1 functional block diagram.

  • Page 25

    Av. Kit install. Manual 190-00026-00 rev. Q page 25 fig a-2 fuselage stations and weight and balance data.

  • Page 26

    Av. Kit install. Manual 190-00026-00 rev. Q page 26 fig a-3 panel layout and breaker location.

  • Page 27

    Av. Kit install. Manual 190-00026-00 rev. Q page 27 fig a-4 wiring diagram.

  • Page 28

    $y.Lw,qvwdoo0dqxdo 5hy4 3djh appendix b connector changes stamped contact connector usage garmin panel mount gps radios have previously been shipped with stamped crimp type contacts. All products are now being shipped with machined mil-spec contacts with color-coded barrels. The following figures ca...

  • Page 29

    Av. Kit install. Manual 190-00026-00 rev. Q page 29 appendix c stc permission consistent with n8110.69 or order 8110.4, aviation authority approved installers are hereby granted permission to use stc# sa00066wi data to modify aircraft..

  • Page 30

    Av. Kit install. Manual 190-00026-00 rev. Q page 30