Garmin GWS 10 Marine Wind Sensor Configuration Manual - page 2
TIp: The angles are configured clockwise around the mast of the boat. For example,
90 degrees is on the starboard side of the boat, and 270 degrees is on the port side.
Configuring the Wind Speed Filter
The wind speed filter governs how quickly the NMEA 2000-compatible display device
shows a change in the wind speed. A lower filter setting shows changes in the wind speed
more gradually, and may stabilize the display.
To configure the wind speed filter:
1. WhileviewingtheNMEA2000deviceinformation,select
Config
>
Wind Speed Filter
.
2. Choose from the following options to adjust the filter settings.
Off
—the wind speed data is not filtered.
On
—selectalowernumbertoshowachangeinthewindspeedmoregradually,and
helpthegaugeneedleorwindspeednumbertomoveorchangemoresteadily.
Auto
—automatically adjusts the filter settings based on wind conditions.
Configuring the Wind Angle Filter
The wind angle filter governs how quickly the NMEA 2000-compatible display device
shows a change in the wind angle. A lower filter setting shows changes in the wind angle
more gradually, and may stabilize the display.
•
•
•
To configure the wind angle filter:
1. WhileviewingtheNMEA2000deviceinformation,select
Config
>
Wind Angle Filter
.
2. Choose from the following options to adjust the filter settings.
Off
—the wind angle data is not filtered.
On
—selectalowernumbertoupdatethedisplaydevicelessoften,andhelpthe
gaugeneedleorwindanglenumbertomoveorchangemoresteadily.
Auto
—automatically adjusts the filter settings based on wind conditions.
Configuring the GWS 10 if the Filter and Offset
Selections Are Not Displayed
Depending on the version of software loaded on your Garmin marine instrument, the
specific configuration options may not be displayed on the configuration screens.
To configure the wind angle offset if the menu option is not displayed:
1. Select
Generic Configuration
to specify data for the filter and offset settings.
2. Enterthefollowingcommand:
“ANGLEOFFSET=”
3. Followthecommandwithanumberbetween0and359,indegrees(forexample:
ANGLEOFFSET=180).
To configure the wind angle filter if the menu option is not displayed:
1. Select
Generic Configuration
to specify data for the filter and offset settings.
2. Enterthefollowingcommand:
“ANGLEFILTER=”
3. Followthecommandwithanumberbetween0and254,representingatimeconstant
inincrementsof0.25second,or255torepresenttheAutomaticsetting(forexample:
ANGLEFILTER=12).
•
•
•