Garmin Intelliducer NMEA 2000 Thru-hull Sensor 0-12° deadrise Installation Instructions Manual - page 4
Transom Mount Intelliducer Installation Instructions
Step 3 (NMEA 2000): Connect the Intelliducer to a NMEA 2000 Network
The Intelliducer is packaged with a NMEA 2000 T-connector. The Intelliducer has a built-in
NMEA 2000 drop cable. Use these two components to connect the Intelliducer to your existing
NMEA 2000 network. If you do not have an existing NMEA 2000 network, you will need to
install a NMEA 2000 network on your boat. For more information on NMEA 2000, visit
To connect the Transom Mount Intelliducer to your existing NMEA 2000 network:
1. DetermineanappropriatelocationtoconnecttheIntelliducertoyourexistingNMEA2000
backbone.
2. DisconnectonesideofaNMEA2000T-connector,ordisconnectaterminatorfromthe
backbonenearesttothelocationwhereyouwanttoconnecttheIntelliducer.
IfyouneedtoextendtheNMEA2000backbone,connectanappropriateNMEA2000
backboneextensioncable(notincluded)totheT-connectororterminatoryoudisconnected.
3. ConnecttheincludedT-connectorfortheIntelliducerintheNMEA2000backbone.
4. Routethebuilt-indropcableontheIntelliducertothebottomoftheT-connectoryouadded
toyourNMEA2000network.
Connecting the Intelliducer to a NMEA 2000 Network
T-connector
(included)
Drop cable
(built-in)
Transom mount Intelliducer
Existing NMEA 000 network
(not included)
Additional
NMEA 000
device
(not included)