Garmin Intelliducer NMEA 2000 Thru-hull Sensor 0-12° deadrise Installation Instructions Manual - 0183-Compliant Device
5
Transom Mount Intelliducer Installation Instructions
Step 3 (NMEA 0183): Connect the Intelliducer to Power and a NMEA
Connect the Intelliducer to Power and a NMEA
0183-compliant Device
The Transom Mount NMEA 0183 Intelliducer must be connected to power. Use the diagrams to
correctly wire the Intelliducer. In the diagrams, Tx = transmit, and Rx = receive.
You can connect up to three NMEA 0183-compliant devices to receive data from one
Intelliducer.
>
>
>
>
Color
Red
Black
Orange
Gray
White/Red
White
White/
Orange
Function
Power
Ground
Acc. On
Tx A(+)
Tx B(-)
Spare
Spare
Fuse
A
Transom Mount NMEA 0183 Intelliducer Power/Data Cable
+
-
>
>
>
>
NMEA 0183-
Compliant
Device
Orange
Red
Black
Power
Ground
ACC On
NMEA 0183
Intelliducer
Gray
White/Red
Rx A(+)
Rx B(-)
Fuse
A
Battery
12 Vdc
Transom Mount NMEA 0183 Intelliducer Wired to a NMEA 0183-compliant Device
Exceptions:
IfyourNMEA0183-compliantdevicehasonlyonereceivingwire(Rx),connectitto
thegraywire(TxA)fromtheIntelliducer,andleavethewhite/redwire(TxB)fromthe
Intelliducerunconnected.
NOTE: The orange (accessory on) wire is used when wiring the Intelliducer to a Garmin
chartplotter or other NMEA 0183 device that has a defined accessory signal wire. If you are wiring
the Intelliducer to a device that does not have an accessory signal wire, the orange wire from the
Intelliducer should be connected to ground.
CAuTION: If you are wiring the Intelliducer to a device that does not have an accessory
signal wire, connect the Intelliducer power wire to the ignition or install an in-line switch. The
Intelliducer can drain the boat battery if it is not switched.
•