Garmin nüvi 660 Installation Instructions

Other manuals for nüvi 660: Owner's Manual

Page of 4

Download

Bookmark us

zūmo 660 Installation Instructions

Mount Your zūmo on the Motorcyle

Warning: Incorrectly wiring the power cable with bare wire leads can result in

damage to the vehicle or the battery and can cause bodily injury. Garmin strongly

recommends having an experienced installer with the proper knowledge of electrical

systems install the unit.

See the Important Safety and Product Information guide in the product box for product warnings

and other important information.

Step 1: Connect Power to the Mount

Select a suitable and secure location to mount the zūmo on your motorcycle, based on

available power sources and safe cable routing.

Cradle

Headphone/audio out jack (3.5 mm)

Microphone jack (2.5 mm)

Mini-USB connector

(for traffic receiever)

Bare wires with

inline fuse for

power connection

Power cable

Step 2: Install the Handlebar Base

The zūmo includes parts for two handlebar installation solutions. Custom mounts can

A) To install the U-bolt and handlebar base:

1. Place the U-bolt around the handlebar, and thread the ends through the handlebar

base.

2. Tighten the nuts to secure the base. Do not overtighten.

note: The recommended torque is 50 lbf-in. Do not exceed torque of 80 lbf-in.

Handlebar

base

Handlebar

U-bolt

Page 1
Zūmo 660 installation instructions mount your zūmo on the motorcyle warning: incorrectly wiring the power cable with bare wire leads can result in damage to the vehicle or the battery and can cause bodily injury. Garmin strongly recommends having an experienced installer with the proper knowledge of...
Page 2
B) to install the handlebar base to the clutch/brake clamp bracket: note: both 1/4 in. Standard and m6 bolts are included. Match the size of the factory bolts on your clutch/brake clamp bracket. 1. Remove the two factory bolts on your clutch/brake clamp bracket. 2. Thread the new bolts through the h...
Page 3
Step 4: attach the base plate to the handlebar base 1. Align the ball of the handlebar base and the ball of the base plate with the double- socket arm. 2. Tighten the knob slightly. 3. Adjust for better viewing and operation. 4. Tighten the knob to secure the mount. Step 5: install your zūmo in the ...
Page 4: Warning: Do Not Use
Mount your zūmo in an automobile 1. Plug the automotive power cable into the connector on the right side of the cradle. 2. Remove the clear plastic from the suction cup. Clean and dry your windshield and the suction cup with a lint-free cloth. 3. Place the suction cup on the windshield. 4. Flip the ...