Rino ® 600 series quick start manual.
Set up the radio. Acquire satellite signals. Battery. Tone. If enabled getting started warning see the important safety and product information guide in the product box for product warnings and other important information. When using your device the first time, complete these tasks. 1. Install the b...
➋ hold to turn on or off the unit. Select to adjust backlight, volume, squelch level, and to lock or unlock the screen. ➌ hold to talk. Ptt stands for push-to-talk. Manual conventions all the pages are found on the home screen. Use or to scroll through the pages. The small arrows (>) used in the tex...
Installing the lithium-ion battery note: the lithium-ion battery pack can be used with only the rino 650 and 655t. 1. Locate the battery pack ➊ that came in the product box. ➊ 2. Align the metal contacts on the battery pack with the metal contacts on the back of the unit. 3. Gently press the battery...
4. Charge the device completely. A fully charged battery can run for up to 14 hours before it must be recharged. Installing aa batteries instead of the lithium-ion battery pack, you can use alkaline, nimh, or lithium batteries. This is especially handy when you are on the trail and cannot charge the...
Radio the radio page provides the user interface for family radio service (frs) and general mobile radio service (gmrs) radio operations. Channels the rino has a total of 30 channels and 121 squelch codes. Channel frequency 1-7 gmrs and frs channels 8-14 frs channels 15-22 gmrs channels 15r-22r repe...
, or navigate to their location you must save the contact. Contacts the first time a signal is received from another rino user, the new contact page appears. From that page you can show their location on the map, add them to your contacts list. Saving a new contact when a new contact signal is recei...
3. Select . 4. Select an option: • select send note to send without saving. • select save. • select send and save. About peer-to-peer positioning note: you can send a location only once every 30 seconds, due to fcc restrictions. You can send your location to another rino using peer-to-peer positioni...
Navigating to a destination you can use the where to? Menu to navigate to a destination. Not all where to? Categories are available in all areas and maps. 1. Select where to?. 2. Select a destination. 3. Select go. Map represents your location on the map. As you travel, the moves. When you are navig...
And photos with the camera waypoint. 1. From the compass, select menu. 2. Select calibrate compass > start. 3. Follow the on-screen instructions. Tracks a track is a recording of your path. The track log contains information about points along the recorded path, including time, location, and elevati...
