Summary of VECTOR 3 A03220
Page 1
Vector™ 3 a03220 owner’s manual.
Page 2
© 2017 garmin ltd. Or its subsidiaries all rights reserved. Under the copyright laws, this manual may not be copied, in whole or in part, without the written consent of garmin. Garmin reserves the right to change or improve its products and to make changes in the content of this manual without oblig...
Page 3
Introduction read all instructions carefully before installing and using the vector system. Improper use could result in serious injury. See the important safety and product information guide in the product box for product warnings and other important information. Move your bike chain to the largest...
Page 4
5 tighten the cleat firmly to the shoe. Note: garmin recommends torque of 4 to 6 lbf-ft. (5 to 8 n- m). Adjusting the release tension do not overtighten the release tension screw on the bottom of the pedal. The release tension should be adjusted equally for both pedals. Use a 3 mm hex key to adjust ...
Page 5
1 rotate the pedals a few times in order to activate vector 3. 2 from the home screen, select > sensors > > sensor details > crank length. 3 enter the crank length, and select . Setting the installation angle before you set the installation angles, you must set the edge data fields to display power ...
Page 6
2 plug the small end of the usb cable into the usb port on the device. 3 plug the large end of the usb cable into a computer usb port. 4 go to www.Garminconnect.Com/start . 5 follow the on-screen instructions. Garmin connect you can connect with your friends on garmin connect. Garmin connect gives y...
Page 7
Water resistance ipx7 notice do not submerge or pressure wash the components. Radio frequency/ protocol 2.4 ghz ant+ wireless communications protocol bluetooth® smart wireless technology battery information vector 3 monitors the battery level of both pedal pods and sends status information to your e...
Page 8
Other compatible devices edge 810 and 510 device instructions pairing vector 3 with your edge 810 or 510 device 1 bring the edge device within range (3 m) of the sensor. Note: stay 10 m away from other ant+ sensors while pairing. 2 turn on the edge device. 3 from the home screen, select > bike profi...
Page 9
5 select your sensor. 6 select status > on. When the sensor is paired with your fēnix device, the sensor status changes from searching to connected. Customizing the data fields 1 hold menu. 2 select settings > sensors > activity > bike > data pages. 3 select add page, and follow the on-screen instru...
Page 10
Power - if: the intensity factor ™ for the current activity. Power - kj: the accumulated work performed (power output) in kilojoules. Power - lap: the average power output for the current lap. Power - lap max.: the top power output for the current lap. Power - last lap: the average power output for ...
Page 11
Performing a static torque test the static torque test is intended for advanced cyclists and installation experts. This test is not required under normal circumstances to achieve good results with the vector 3 system. This test is available for the edge 1000, 810, and 510 devices. Garmin recommends ...
Page 12: Support.Garmin.Com
Support.Garmin.Com june 2017 190-02235-00_0a.