Garmin VECTOR 3 A03220 Owner's Manual - page 4
5
Tighten the cleat firmly to the shoe.
NOTE: Garmin recommends torque of 4 to 6 lbf-ft. (5 to 8 N-
m).
Adjusting the Release Tension
Do not overtighten the release tension screw on the bottom of
the pedal. The release tension should be adjusted equally for
both pedals.
Use a 3 mm hex key to adjust the release tension of each
pedal.
There is a window on the back of the pedal binding that
shows the allowable range.
Paring Vector 3 with Your Edge 1000
Before you can view Vector 3 data on the Edge device, you
must pair the devices.
Pairing is the connecting of ANT+
®
wireless sensors. This
procedure contains instructions for the Edge 1000. If you have
another compatible device, see
Other Compatible Devices
,
page 6
, or go to
www.garmin.com/Vector3owner
.
1
Bring the Edge device within range (3 m) of the sensor.
NOTE: Stay 10 m away from other ANT+ sensors while
pairing.
2
Turn on the Edge device.
3
From the home screen, select
> Sensors > Add Sensor >
Power.
4
Rotate the crank arm a few times.
5
Select your sensor.
When the sensor is paired with your Edge device, a message
appears, and the sensor status is Connected. You can
customize a data field to display Vector 3 data.
Pedal Pod Status LED
Multiple green or red LED flashes indicate a system issue that
requires your attention.
Installing the Shoe Cleats
NOTE: The left and right cleats are the same.
1
Apply a thin layer of grease on the cleat bolt threads.
2
Align the cleat
À
, washers
Á
, and bolts
.
3
Use a 4 mm hex key to loosely attach each bolt to the sole of
the shoe.
4
Adjust the cleat to the shoe in your preferred position.
This can be adjusted after a trial ride.
Your First Ride
Before you ride with Vector 3 for the first time, you must enter
the crank length and set the installation angle of the sensors
inside the pedals. The Vector 3 system automatically calibrates
after each ride. You must also enter the crank length when you
move Vector 3 to another bike.
This procedure contains instructions for the Edge 1000 device. If
you have another compatible device, see
Other Compatible
Devices
, page 6
, or go to
www.garmin.com/Vector3owner
.
Entering the Crank Length
The crank length is often printed on the crank arm.
2
Introduction
NOTICE
LED Activity
Status
1 green flash every 10
seconds.
The Vector system is working properly.
3 green flashes every
10 seconds.
Cannot connect to the other pedal.
1 red flash every 10 seconds.
The battery is low.
20 green flashes
File transfer or software update was
successful.
20 red flashes
File transfer or software update failed.