GOLDEN MASK 5+ User Manual - Select
Golden Mask 5 User Guide
GMD -
www.goldenmaskdetectors.com - Golden Mask Official Reseller
10
Golden Mask 5 User Guide
GMD -
www.goldenmaskdetectors.com - Golden Mask Official Reseller
11
2. Two-tone (2)
In two-tone or bitonal mode, you hear both signal from ferrous and non-ferrous targets.
Ferrous targets are indicated with a low sound, while the sound response from non-
ferrous targets is with high frequency sound. You can tune-up the sound frequencies for
different targets by selecting the sound button (with the speaker icon), then select the
TONE option and confirm with ENTER.
Then select the tone you want to change (for non-ferrous or ferrous targets) and select the
desired frequency by pressing the - and + buttons. As usual, confirm your choice by press-
ing the ENTER button.
SELECT
volume
tone
SELECT TONE
non-FE
All
ferrous
A new screen with tone values will appear. Select the desired frequency by pressing the
- and + buttons. On every change, you will hear the signal from your selection, Once you
choose the sound you like, confirm your choice by pressing the ENTER button.
The bitonal mode is good if you want to hear the non-ferrous metals. This is usual for new
areas, where the presence of iron could give you valuable information about the place.
Many people like to always hear the non-ferrous targets and this is not a problem with the
Golden Mask 5 even in very polluted areas, because of the fast response of the detector.
To work good in areas with lots of iron trash, the DL setting should be set at or near the
maximum value of 15 and the sensitivity (PL, power level) should be lowered to 10-15.
1
2
FERROUS
5
6
4
NON FERROUS
20
21
19