GoldenEar Technology SuperSat Owner's Manual - Speaker Connection
GoldenEar Technology
►
SuperSat Series Manual
SuperSat Series Owner’s Manual
10
Speaker Connection
Your SuperSat speakers are equipped with a set of 5-way binding posts that can be used with bare wire, pin or
spade connectors or banana plugs. Tighten the posts firmly by hand, but do not over tighten them. Make sure all
wires are firmly fastened. Always use high quality speaker wire of sufficient gauge for the distances you are running
(see you dealer for assistance).
For the front SuperSat speakers, hook up the left main/front channel red(+) terminal of your receiver or amplifier
to the red(+) terminal of your left loudspeaker and the left main/front channel black(-) terminal of your receiver
or amplifier to the black(-) terminal of your left loudspeaker. Connect the right channel main/front channel
red(+) terminal of your amplifier or receiver to the red(+) terminal of your right loudspeaker and the black(-)
terminal of the right main/front channel of your receiver or amplifier to the black(-) terminal of your right loud-
speaker. It is essential that both speakers be connected in the same way (in phase) to its own channel of the
amplifier. If you experience a great lack of bass, it is likely that one speaker is out of phase (+ and – reversed)
with the other.
If you are using the SuperSat speaker as surround speakers, hook up the left surround red(+) terminal of your
receiver or amplifier to the red(+) terminal of your left surround speaker and the left surround black(-) terminal of
your receiver or amplifier to the black(-) terminal of your left surround speaker. Connect the right surround red(+)
terminal of your amplifier or receiver to the red(+) terminal of your right surround loudspeaker and the black(-)
terminal of the right surround channel of your receiver or amplifier to the black(-) terminal of your right surround
loudspeaker. Again, it is essential that both speakers be connected in the same way (in phase) to its own chan-
nel of the amplifier.
If you are using the SuperSat 3C/50C center channel speaker, hook up the center red(+) terminal of your re-
ceiver or amplifier to the red(+) terminal of your center speaker and the center black(-) terminal of your receiver
or amplifier to the black(-) terminal of your center speaker.
Turn your amplifier/receiver Off before performing any connection steps,
in order to prevent accidental damage to your amplifier.