GoldenEar Technology SuperSat Owner's Manual - Wall Mounting Instructions
GoldenEar Technology
►
SuperSat Series Manual
SuperSat Series Owner’s Manual
12
Complete Home Theater Systems
We strongly suggest that you use matching GoldenEar Technology SuperSat center channel and rear/surround
speakers, and a ForceField
™
subwoofer, to complete your GoldenEar home theater system. SuperSat speakers
are designed to be used as rear or side surround speakers as well, with exceptional results for both music and
movies. Of particular note, the GoldenEar ForceField
Subs have been designed specifically to make a perfect
match with the SuperSat speakers.
Wall Mounting Instructions
If you are not comfortable performing the following mounting procedures we strongly suggest having a
professional wall mount your speakers (see your Dealer). Please note that hardware for the wall is not included
— make sure to use hardware appropriate for your wall type and the weight of the speaker being mounted.
Tools Required:
• Wall Mount Template (included)
• Pencil
• Level
• Drill (as needed, depending on hardware used)
• Screwdriver
• Appropriate Wall Mounting Hardware with
#10 pan head screw to fi
t the mounting keyhole
on the back of the speaker
Instructions (after the speaker wires have been run and are in place):
1. Place Template in the desired location on the wall. Use the level to make sure the template is straight;
2. Use the pencil to mark the mounting screw locations indicated on the mounting template using the
holes in the template marked “Pilot Holes”;
3. Install your mounting hardware in this location, leaving
1
/
8
" (3mm) of space between the back of
the screw head and the wall.
4. Carefully align the keyholes in the back of the SuperSat with the screws in the wall and gently slide
the speaker into place.
5. If the speaker does not slide in place, back the screws out a turn and try again; If the speaker is loose,
turn the screws in another turn and try again. Repeat as necessary.
NOTE:
The threaded insert on the back panel is a
1
/
4
"–20 UNC x 0.5" (16mm) deep thread for use with various
after market mounting brackets as well as the optional matching SuperSat floor and table stands.