Goldmund TELOS 390 User Manual - page 8
4
User manual - GOLDMUND TELOS 390 INTEGRATED AMPLIFIER |
P 7
A M P L I F I E R C O N T R O L S
POWER
The TELOS 390 Integrated Amplifier is powered on using the switch located on the back
panel. In regular use this switch should be left ON at all times (see sound quality
optimization). The standby function of the remote control should be used to mute the signal
for safe removal of cables. When in standby mode the front panel operation LED will blink
intermittantly.
The amplifier is powered OFF by switching the back panel switch to the OFF position. A safety
circuit switches the unit to mute to avoid any disturbance reaching the speakers.
MUTING
To mute the preamplifier output, press the "MUTE" key. The same operation repeated brings
back the amplifier to normal operation at the same volume as in operation at the point the
mute function was activated.
VOLUME ADJUSTMENT
The level control may be adjusted manually using the front panel knob or by using the + and
- buttons on the remote control.
SELECTOR
The selector now selects one of eight available inputs (5 analog and three digital). Each step
clockwise selects the next input in sequence. Selection may also be made using the remote
control by pressing the key corresponding to the input on the remote control.
OPENING VOLUME MEMORY
This function is only accessible via the remote control. It allows the volume to be
automatically set to the level fixed when the unit is turned ON.
To adjust the level, first select the desired output level, then press MEMO on the remote
control.
If at any time during playback you wish to retun to this level, just press the RESET button.