Goldwing Corvus Racer 540 30CC Manual - page 12
● Cut out the area for the engine cylinder head and the exhaust outlet on a piece of thin card and
tape this to the fuselage at one end.
● Remove the engine and fit the cowl, then fold the card back over.
● Mark the area and cut out using a dermal. Ensure that enough air can get out of the cowl. The
ratio is usually three times out to one in.
● Fit the ignition on the side of the motor box. Use Velcro and a strap to ensure it does not come off
with vibration.
● The cowl is fixed in 4 places, 2 at the top and 2 at the bottom. Place masking tape over the bottom
2 and pierce where the blind nut hole is.
● Refit the cowl and drill where the marked hole was.
● The fuel tank is pre-installed. Attach petrol proof pipe as per labelling on tank
● Use the supplied pushrod with a ball joint to connect to the throttle arm on the engine. Then find a
convenient place to locate the throttle servo using the supplied mount.