Goldwing Corvus Racer 540 30CC Manual - page 2
Unpacking
Carefully unpack the model making sure to cut any c
sharp knife. Inspect each item to make sure no transit damage has occurred . If you
are not happy with any part or are unsure , please contact the Dealer that you purchas
-ed from.
overing on the model if using a
Covering
Due to the model spe
some of the covering may have wrinkles. We highly recommend that you take time to
re -seal all covering edges with an iron and to use a heat gun to remove any wrinkles
and re-tighten the covering. It is best to do this now while the plane is not assembled.
nding time indifferent climates on its way from factory to you,
Note:
Do not let any heat get near parts like the canopy or cowl as this may cause damage.
Assembly Tips
We also recommend that you go over all the
major
accessible joints with some C.A. glue.
Also wick thin C.A. glue into areas of high stress around the U/C plate and motor box.
Use a thread locker on all
metal-to-metal
joints. Even if you are using electric with low
vibration
do not drop off your airplane!
levels it will make sure that things