Hot water pressure washers hpw-2600g and hpw-3500g operating and maintenance instructions goodway technologies corporation 420 west avenue stamford, ct 06902 203-359-4708 sales: 800-333-7467 customer service: 800-370-2855 fax: 800-359-9625 e-mail: goodway@goodway.Com internet: www.Goodway.Com goodwa...
Important safety instructions 1. Read all safety and operating instructions before using unit. 2. Read warnings on additive containers. 3. Ventilate work area when using toxic or pungent additives to reduce your exposure to toxic fumes. 4. Use protective wear, especially for the eyes and skin. 5. Be...
Pre-operating instructions when unpacking the unit, if you find damage due to shipping, contact goodway technologies immediately. Incoming water supply connect a garden hose to the water inlet of the unit. The water supply must be able to deliver 8 gallons per minute at a minimum pressure of 5 psi. ...
Operating instructions starting the pressure washer make sure that the burner switch is “off” connect water supply to the washer. Turn on the water. Pull the trigger to allow water to run through the unit expelling all air. Caution never run the washer without water turned on. Pump damage will occur...
Burner start up instructions note: the following steps are only required when installing a new burner. 1. Set the thermostat substantially above water temperature of the incoming water supply. (in temperate regions, this is around 50 degrees fahrenheit.) 2. Turn on the burner switch. 3. As soon as t...
Safety components unloader valve the unloader valve allows all of the water delivered by the pump to return to the pump suction side. If the trigger gun is closed or “off”, the unloader valve goes into the “bypass mode” and the pump runs without pressure. However, the pump may be severely damaged, d...
Winterizing your pressure washer (this is also good practice if the cleaner is to remain unused for more than 3-4 weeks.) • • • • • • • shut off the water supply and disconnect hose. You need a short (2”) length of hose with a male garden hose fitting on one end. Connect the short hose to the inlet ...
Trouble shooting (continued) excessive pressure outlet orifice restricted remove orifice at tip of gun and clean. Flush coil with water before replacing. Scale or dirt in coils de-scale coils pump speed too high check water output gpm relief valve operates relief valve set at low pressure re-adjust ...
Spark. Plugged oil nozzle replace (do not clean) faulty burner oil pump adjust or replace unit smokes improper fuel use home heating oil, kerosene or diesel fuel air to burner insufficient air adjustment on burner – remove soot from coils fuel nozzle interior loose replace nozzle water temperature t...
9509 10” 9534 13” wheel 9511 (3500) 9535 (2600) switch 9506 coil 9505 (3500) 9531 (2600) coil cap 9512 (3500) 9536 (2600) thermostat 9510 axle cap 9513 13 hp (3500) 9538 6.5 hp (2600) briggs & stratton engine 9508 (3500) 9533 (2600) blow off valve 9518 motor 9515 fuel solenoid 9516 fuel pump 9517 ig...
9520 hose 50 ft. Nozzles 9520 9521 male coupler 0° pin point qdn-0004r (3500) qdn-0003r (2600) 15° flat qdn-1504y (3500) qdn-1503y (2600) 25° flat qdn-2504g (3500) qdn-2503g (2600) qdn-lp25 9527 female coupler 11.
12 12.
