H.F.Prints CLB 200 wb User Manual - page 6
of
8
Programming the entire unit:
Connect a laptop with RS232 adapter cable to connect the program to the interface board.
(Interface Print the front print, connection behind the unit (next antenna connector) via a 3.5mm jack)
Open the HyperTerminal program. (desk accessories), or use eq. Program.
Settings:
Port: COM1 ?? depending on the PC
Bits per second 9600
Data Bits 8
Paritity no
Stop bit 1
Flow control no
The settings for communications made now.
Reading memory button
P
Channel Change
key line number than channel name
Change frequency
key line number than frequency