H.Koenig EXP350 Instruction Manual - page 3
B. MAKE ESPRESSO COFFEE
1. Open the lid, take out water tank, and pour appropriate water into tank. Do
not exceed the MAX capacity;
2. Put back the water tank and close the lid;
3. Connect power plug, press power button, then machine will automatically
pump water about 2s, and coffee indicator and steam indicator always light
on, then coffee indicator is flashing and the machine start preheating, coffee
indicator will light on and then preheating finished after 2min;
4. Take out filter holder, pour appropriate coffee powder into the filter with coffee
spoon, then press the coffee powder tightly;
5. Lock the filter holder into the group head
6. Put cup(s) under coffee outlet;
7. Start brewing by pressing coffee button;
8. Remove filter holder, knock it out and clean it with hot water immediately, and
lock it again for next use.
Note: Check frequently the water level in the tank. Refill if necessary.
Do not use hands to touch the hot surfaces of machine, especially
brewing outlet, steam nozzle when use machine.
C. FROTHING MILK/ MAKE CAPPUCCINO
1. Prepare espresso first with a large enough cup according to part “B. MAKE
ESPRESSO COFFE.
2. Use whole, fresh cold milk out of the fridge(8
℃-10℃), and pour 1/3 milk in
cup.
Note: Use a stainless steel cup, and cup diameter should not less than
70 ± 5mm, due to the volume of milk will increase after frothing.
3. Press steam button, it starts preheating, and steam indicator is flashing, then
wait for lamp lights on;
4. Put a stainless steel cup under steam nozzle;
5. Open knob, release steam, make the steam nozzle floating on the surface of
milk, and adjust the height of steel cup to froth milk;
6. Remove product when finished, turn off the knob, and Pour the frothed milk
into the espresso prepared; now the cappuccino is ready.
TROULBE SHOOTING
Problem
Cause/Result
Solution
No water
comes out
Water tank is empty
Pour water in water tank
The input voltage or
frequency is inconsistent
with nameplate
Make sure the voltage and frequency is
consistent with the nameplate
machine malfunctions
please contact with the authorized service
No steam is
generated
steam nozzle clogged
Clean steam nozzle
Water tank is empty
Pour water in water tank
Machine malfunctions
please contact with the authorized service
Coffee runs
out around
the edge of
the filter
holder
Too much coffee in filter
clean the filter, then pour appropriate coffee
powder
There is coffee in the seal
under group head
Clean the seal under group head
Implementation of the
above operation
problems still exist
please contact with the authorized service
Coffee
comes out
too slow or
no coffee
comes out
coffee grind is too fine,
and clogged filter
With thicker coffee powder
Filter holes are blocked
Brush / clean the filter
Water tank is not inserted
Insert the water tank in place
There is
water
leakage on
the bottom of
coffee
machine
Drip tray is filled up
Please clean the drip tray
Machine malfunctions
please contact with the authorized service
Machine is
not working
The power outlet is not
plugged well.
Plug the power cord into a wall outlet
correctly,
NTC is short circuit
please contact with the authorized service
Machine malfunctions
The steam
cannot froth.
Steam indicator is
flashing
Wait steam indicator lights on.
The container is too big
Use high and narrow cup or garland cup