H&S XRT Pro Installation & Operation Manual - Transmission Relearn
22 XRT Pro Installation Manual • www.hsperformance.com
1. low: This option will shift into high gears at the lowest possible road speed.
2. Med: This option is the middle range of shift points
3. High: This option will shift into high gears at the highest possible road speed.
TPMs adjustability / Disable
Many 2008 - 2010 6.4L Powerstrokes are equipped with a TPMS or Tire Pressure Monitoring
System from the factory. This system is designed to alert the driver of a problem with the
vehicles tire pressures but is often a nagging inconvenience for those individuals wanting to
run lower pressures or get rid of the TPMS sensors altogether.
H&S Performance has a designed solution for those individuals. By using your H&S tuning
device and a 6.4L Powerstroke TPMS Adapter (Part #709913), you will have full control of the
TPMS. Front and rear tire pressures will be independently adjustable from 0 - 100 PSI as well
as the option to Disable the TPMS completely if removing the TPMS sensors from the vehicle.
All changes to the TPMS must be done with the 6.4L Powerstroke TPMS Adapter in place and
the Adapter must be removed after changes are made to resume normal tuner function.
Transmission relearn
The 5R110 automatic transmission on the 2008 - 2010 6.4L Powerstroke has what is called
adaptive Memory and is constantly learning and adapting to different horsepower levels,
temperatures, driving habits, etc. After completing the Install Download process on the 6.4L
Powerstroke, the Transmission Adaptive Memory is automatically reset. We highly recom-
mend performing a Transmission Relearn procedure after installing H&S tuning to help the
transmission perform correctly with the added horsepower. The 5R110 automatic trans-
mission will eventually learn over time on its own, but the relearn procedure gives a good
baseline for the adaptive learning and helps to speed up the learning process. To perform
the relearn procedure, please follow these instructions:
When re-training the transmission, ALWAYS follow posted speed limits. Do NOT at-
tempt runs in adverse weather conditions such as snow, ice, rain, wind, or any other
conditions that may affect your vehicles traction or impair your visibility!
1. After H&S tuning is installed, perform each of the following 0-80 MPH runs while in the
Performance power level. During this relearn process, you may experience hesitation
during shifts, hard shifts, or defuel patterns, all of which are normal:
•
0-80 MPH @ 25% throttle position, then slow down and come to a complete stop.
•
0-80 MPH @ 50% throttle position, then slow down and come to a complete stop.
•
0-80 MPH @ 100% throttle position, then slow down and come to a complete stop.
The Transmission relearn procedure is complete.
noTe:
On any vehicle using 3” or larger lift blocks under the rear leaf pack, it is HIGHLY RECOMMENDED to install
traction bars. With any added horsepower, failure to do so may result in harsh shifting and may cause premature
transmission and/or driveline damage.