H3C H3C S5600 Series Operation Manual

Summary of H3C S5600 Series

  • Page 1

    Operation manual – irf fabric h3c s5600 series ethernet switches-release 1510 table of contents i table of contents chapter 1 irf fabric configuration............................................................................................. 1-1 1.1 overview ..........................................

  • Page 2

    Operation manual – irf fabric h3c s5600 series ethernet switches-release 1510 chapter 1 irf fabric configuration 1-1 chapter 1 irf fabric configuration 1.1 overview 1.1.1 introduction to irf several irf (intelligent resilient framework) supported switches of the same model can be interconnected to f...

  • Page 3

    Operation manual – irf fabric h3c s5600 series ethernet switches-release 1510 chapter 1 irf fabric configuration 1-2 1.1.2 introduction to rmon on irf the remote monitoring (rmon) configurations of the devices in a fabric are the same. The rmon configuration performed on a device of a fabric will be...

  • Page 4

    Operation manual – irf fabric h3c s5600 series ethernet switches-release 1510 chapter 1 irf fabric configuration 1-3 z if the switch can receive disc packets sent by the peer, the ftm module determines whether peer sending ports correspond to local receiving ports according to information in the pac...

  • Page 5

    Operation manual – irf fabric h3c s5600 series ethernet switches-release 1510 chapter 1 irf fabric configuration 1-4 prompt analysis solution two fabric ports of the same device (that is, the right port and the left port) are connected. Pull out one end of the cable and connect it to a fabric port o...

  • Page 6

    Operation manual – irf fabric h3c s5600 series ethernet switches-release 1510 chapter 1 irf fabric configuration 1-5 1.3 irf fabric configuration 1.3.1 introduction to irf fabric configuration ftm provides user interfaces. You can configure unit ids, fabric name by using a related command. Table 1-2...

  • Page 7

    Operation manual – irf fabric h3c s5600 series ethernet switches-release 1510 chapter 1 irf fabric configuration 1-6 after an irf fabric is established, you can use the following command to change the unit ids of the switches in the irf fabric. Table 1-4 set a unit id to a new value operation comman...

  • Page 8

    Operation manual – irf fabric h3c s5600 series ethernet switches-release 1510 chapter 1 irf fabric configuration 1-7 table 1-5 save the unit id of each unit in the irf fabric operation command description save the unit id of each unit in the irf fabric fabric save-unit-id optional 1.3.3 specifying t...

  • Page 9

    Operation manual – irf fabric h3c s5600 series ethernet switches-release 1510 chapter 1 irf fabric configuration 1-8 operation command description assign a unit name to a switch set unit unit-id name unit-name required 1.3.5 assigning an irf fabric name to a switch only the switches with the same ir...

  • Page 10

    Operation manual – irf fabric h3c s5600 series ethernet switches-release 1510 chapter 1 irf fabric configuration 1-9 table 1-9 display and debug ftm operation command description display the information about an irf fabric display irf-fabric [ status ] display the topology information of an irf fabr...

  • Page 11

    Operation manual – irf fabric h3c s5600 series ethernet switches-release 1510 chapter 1 irf fabric configuration 1-10 1.5.3 configuration procedure 1) configure switch a. # configure the unit id as 1. System-view [h3c] change unit-id 1 to 1 # configure the unit name as unit 1. [h3c] set unit 1 name ...