H3C S9500 Series Operation Manual - page 16
Operation Manual – MPLS OAM
H3C S9500 Series Routing Switches
Chapter 1 MPLS OAM Configuration
1-15
Lsp ingress lsr-id : 1.1.1.1 Auto-protocol :Disable
Auto-overtime (s) : 0
Ttsi/lsr-id : 1.1.1.1
Ttsi/lsp-id : 100
oam detect information: oam backward information:
--------------------------------------------------------------------------
Type : CV Share attribute : Share
Frequency : 1 s Lsp-name : lspCtA
Detect-state : Start Lsp-state : Up
Defect-state : No-defect
--------------------------------------------------------------------------
Verbose information about the 2nd OAM at egress
--------------------------------------------------------------------------
lsp basic information: oam basic information:
--------------------------------------------------------------------------
Lsp-name : lspAtCp Oam-Index : 1025
Lsp signal status : Up Oam select board : 2
Lsp incoming Label : 3 Enable-state : --
Lsp ingress lsr-id : 1.1.1.1 Auto-protocol : Disable
Auto-overtime (s) : 0
Ttsi/lsr-id : 1.1.1.1
Ttsi/lsp-id : 200
oam detect information: oam backward information:
--------------------------------------------------------------------------
Type : CV Share attribute : Share
Frequency : 1 s Lsp-name : lspCtA
Detect-state : Start Lsp-state : Up
Defect-state : No-defect
--------------------------------------------------------------------------
Total Oam Num: 2
Total Start Oam Num: 2
Total Defect Oam Num: 0
# Display the statistics of verification packets received on the egress node.
--------------------------------------------------------------------------
CV Packet FFD Packet FDI Packet AP-FDI Packet Error Packet
--------------------------------------------------------------------------
467 0 0 0 0
6)
Verify the configuration
Shutdown interface VLAN12 of Switch B. At this point, the primary LSP on Switch A
detects a defect.