H3C S9500 Series Operation Manual - page 9
Operation Manual – MPLS OAM
H3C S9500 Series Routing Switches
Chapter 1 MPLS OAM Configuration
1-8
z
Configure MPLS basic capabilities, refer to MPLS Configuration.
z
Configure static LSPs, refer to MPLS Configuration.
3) Data
preparation
To configure MPLS OAM basic capability, prepare the following data:
Table 1-4 Data preparation
Number
Data
1
The static LSP to be verified
2
For ingress node, LSP ID of the static LSP to be verified
For egress node, the ingress LSR ID and LSP ID of the static LSP to
be verified
3
The static LSP of the reverse channel
4
MPLS OAM parameters, for instance, verification packet type and
FFD transmission frequency
If the ingress node adopts a shared reverse channel, the No. 3 data in the above table
is omitted.
II. Configuration Procedure
Follow these steps to configure MPLS OAM basic capability:
To do...
Use the command...
Remarks
Enter system view
system-view
—
Enable MPLS OAM
mpls oam
Required
Configure MPLS OAM
parameters for the
ingress node
mpls oam ingress lsp-name
lsp-name lsp-id lsp-id [ type { cv | ffd
[ frequency ffd-fre ] } ] [ backward-lsp
share | lsp-name rev-lsp-name ]
Required
Enable OAM for the
ingress node
mpls oam ingress enable { all |
lsp-name lsp-name }
Required
Configure MPLS OAM
parameters for the
egress node
mpls oam egress lsp-name
lsp-name lsr-id lsr-id lsp-id lsp-id
[ type { cv | ffd [ frequency ffd-fre ] } ]
[ backward-lsp rev-lsp-name [ private
| share ] ]
Required
Enable OAM for the
egress node
mpls oam egress enable { all |
lsp-name lsp-name }
Required