Haan SELECT SI-60 Instruction Manual - page 10
8
9
Using Your Floor Sanitizer - Operating Instructions
Before Using Your Floor Sanitizer cont.
IMPORTANT
This product is NOT for space heating purposes.
CAUTION
CAUTION
Use only a heavy duty extension cord rated for 15 amps minimum – DO NOT use an
ordinary extension cord.
HAAN® floor care products emit steam at 212º to sanitize the area of use. This
means that the steam head, Ultra-microfiber pads and carpet glide get very hot
during use. Care should be taken when using this appliance and DO NOT touch
components of this machine during use except in the approved manner as outlined
in this manual.
1
4
Assemble unit and place on
floor Protector / Resting mat.
Tighten cap. insert tank (cap
down) until it “clicks”.
2
5
Press Water Tank Release but-
ton and remove water tank.
Press oN/off button. Wait 20
seconds for unit to heat up.
unit may vibrate while heating.
3
6
Turn Cap counterclockwise to
Remove. fill tank with water.
gently place unit on ultra-
microfiber pad. you are now
ready to steam clean.
Floor Setting Indicator Light
Floor Setting Button
7
10
Tilt handle at a 45º angle. Push
and pull slowly across the floor
to clean thoroughly.
When unit has cooled, remove
ultra-microfiber pad. Store
unit upright in a dry area.
8
When done, push oN/off button.
9
Place unit with ultra-microfi-
ber pad attached onto floor
Protector / Resting mat. Allow
to cool down for five (5) min.
FLOOR
SETTING
high steam emission ideal for ceramic,
stone, tile and other durable floors.
gentle steam emission perfect for
sealed hardwood, laminate, bamboo and
other delicate floors.
use this button to switch between two
steam levels, each catering to specific floor
types.
This light indicates which steam floor setting
level is selected.
IMPORTANT: Vibration Sound
IMPORTANT
During use it’s normal to hear a “clicking” sound coming from
the unit. This sound is produced by the water being pumped
through the unit.
Always empty the water tank once you have finished using your
floor Sanitizer.