Hacker DS-5 Instruction Manual - page 17
Seite: 17
Installation of receiver
Whenever possible, you should wrap the receiver in foam and place it as far as possible from
sources of interference (servos, electric motors). Arrange the receiver antennas so that their active
ends form a 90° angle and try to put them as far as possible away from each other. Take care not
to bend them with a radius smaller than 1 cm. The active part of the antenna should not be placed
close to metal
parts. If your model has a carbon fuselage it is very important to place the active antenna ends
outside the fuselage.
Binding
In order to achieve communication between transmitter and receiver you must
bind them. During this process the transmitter learns the receiver address and
will automatically find it again when turned back on. Communication begins with
this receiver automatically if the transmitter is not already communicating with
another
receiver.
The binding process needs only to be done once for each receiver.
Standard pairing procedure:
1.
Switch off the transmitter and receiver.
2.
Plug the „BIND PLUG“ into the EXT receiver input.
3.
Connect receiver power supply.
4.
Switch on the transmitter. The receiver will bind with the primary transmitter module.
5.
The transmitter will confirm with a short-short-long beep. The status LED will flash
red and green.
6.
Remove the bind plug from the receiver.
7.
The status LED will now shine green.
8.
The system is now paired.
This binding process will be saved an only needs to be repeated in case you want to pair a diffe-
rent TX/RX combination. Please store the bind plug safely for the sake of repairing.
EN